Low noise, narrow optical linewidth semiconductor-based optical comb source and low noise RF signal generation
Başlık çevirisi mevcut değil.
- Tez No: 400049
- Danışmanlar: DR. PETER J. DELFYETT
- Tez Türü: Doktora
- Konular: Elektrik ve Elektronik Mühendisliği, Electrical and Electronics Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2011
- Dil: İngilizce
- Üniversite: University of Central Florida
- Enstitü: Yurtdışı Enstitü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 123
Özet
Özet yok.
Özet (Çeviri)
Recently optical frequency combs and low noise RF tones are drawing increased attention due to applications in spectroscopy, metrology, arbitrary waveform generation, optical signal processing etc. This thesis focuses on the generation of low noise RF tones and stabilized optical frequency combs. The optical frequency combs are generated by a semiconductor based external cavity mode-locked laser with a high finesse intracavity etalon. In order to get the lowest noise and broadest bandwidth from the mode-locked laser, it is critical to know the free spectral range (FSR) of the etalon precisely. First the etalon FSR is measured by using the modified Pound-Drever-Hall (PDH) based method and obtained a resolution of 1 part in 106, which is 2 order of magnitude better than the standard PDH based method. After optimizing the cavity length, RF driving frequency and PDH cavity locking point, the mode-locked laser had an integrated timing jitter of 3 fs (1 Hz- 100 MHz) which is, to the best of our knowledge, the lowest jitter ever reported from a semiconductor based multigigahertz comb source. The mode-locked laser produces ~ 100 comb lines with 10 GHz spacing, a linewidth of ~500 Hz and 75 dB optical signal-to-noise ratio. The same system can also be driven as a regeneratively mode-locked laser with greatly improved noise performance.Another way of generating a low noise RF tone is using an opto-electronic oscillator which uses an optical cavity as a high Q element. Due to the harmonic nature of OEOs, a mode selection element is necessary. Standard OEOs use an RF filter having drawbacks such as broad pass band, high loss, and high thermal noise. In our work, a novel optoelectronic scheme which uses an optical filter (Fabry-Perot etalon) as the mode filter instead of an RF filter is demonstrated. This method has the advantage of having ultra-narrow filtering bandwidths ( ~ 10 iv kHz for a 10 GHz FSR and 106 finesse) and an extremely low noise RF signal. Experimental demonstration of the proposed method resulted in a 5-10 dB decrease of the OEO noise compared to the conventional OEO setup. Also, by modifying the etalon-based OEO, and using single side band modulation, an optically tunable optoelectronic oscillator is achieved with 10-20 dB lower noise than dual side band modulation. Noise properties of the OEO as a function of optical frequency detuning is also analyzed theoretically and the results are in agreement with experimental results.The thesis concludes with comments on future work and directions.
Benzer Tezler
- Vakum ortamında, düşük sıcaklıklı, taranabilen harici optik geri beslemeli diyot lazer sistemi platformunun tasarlanması, kurulması ve çalıştırılması
Desinging, establishing and working tunable external cavity diode lazer system platform with optical feedback under low temperature and vacuum
BÜLENT HARUN KILIÇ
Doktora
Türkçe
2021
Fizik ve Fizik MühendisliğiMersin ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
DR. ÖĞR. ÜYESİ HÜSEYİN MUTLU
DR. ÖĞR. ÜYESİ İBRAHİM KÜÇÜKKARA
- EDFA kuvvetlendiricili DWDM/UDWDM uzak mesafe haberleşme sistemlerinde SRS, FWM ve ASE gürültüsü birleşik etkisinin modellenmesi ve benzetimi
Modeling and simulation of the combined effect of SRS, FWM and ASE noise in DWDM/UDWDM long haul communication systems using EDFAs
KÜBRA KILINÇARSLAN
Yüksek Lisans
Türkçe
2022
Elektrik ve Elektronik MühendisliğiBursa Uludağ ÜniversitesiElektronik Mühendisliği Ana Bilim Dalı
DOÇ. DR. SAİT ESER KARLIK
- Development of a static fourier transform spectrometer and real-time substrates for surface enhanced raman scattering
Statik fourier dönüşüm spektrometresi ve gerçek zamanda yüzey geliştirilmiş raman saçılması substratı geliştirilmesi
BEHZAD SARDARI GHOJEHBEIGLOU
- Ses ötesi tezmizlik cihazı ölçümleri sonuçları analizi
Measurements and analysis of results of cleaning device
CEM TUNC
Yüksek Lisans
Türkçe
2013
Elektrik ve Elektronik Mühendisliğiİstanbul Teknik ÜniversitesiElektronik ve Haberleşme Mühendisliği Ana Bilim Dalı
YRD. DOÇ. DR. METİN HÜNER
- Endüstriyel dağılmayan kızılötesi (NDIR) metan (CH4) gaz sensörü tasarımı
Design of an industrial non-dispersive infrared (NDIR) methane (CH4) gas sensor
DİLAN YALÇIN
Yüksek Lisans
Türkçe
2023
Fizik ve Fizik Mühendisliğiİstanbul Teknik ÜniversitesiMekatronik Mühendisliği Ana Bilim Dalı
DOÇ. DR. SERHAT İKİZOĞLU
