Design and development of hall sensors for magnetic microsystems
Manyetik mikrosistemler için koridor algılayıcı tasarımı ve geliştirilmesi
- Tez No: 409230
- Danışmanlar: YRD. DOÇ. HAMDİ TORUN, Prof. GÜNHAN DÜNDAR
- Tez Türü: Yüksek Lisans
- Konular: Elektrik ve Elektronik Mühendisliği, Electrical and Electronics Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2015
- Dil: İngilizce
- Üniversite: Boğaziçi Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Elektrik-Elektronik Mühendisliği Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 70
Özet
Özet yok.
Özet (Çeviri)
Nowadays, magnetic sensors are widely used in variety of applications. One of the most common classes of magnetic sensors is Hall effect based sensors. Improving characteristics of Hall effect based sensors, such as sensitivity, resolution, power consumption, and chip area has always been a center of attention for many researchers. In this work, a Hall sensor is designed in 0:13m CMOS technology. Two cross-shaped Hall plates are used to increase sensitivity and to cancel the DC ofset output of Hall plates. To provide input current for the Hall plates, a biasing circuit is designed. Using a common mode feedback network, consistency of the input current is ensured. To automatically ignore the process variations, which causes asymmetric output from different Hall plate ports, the current spinning method is used. 32 switches are connected to input-output ports of the Hall plates to rotate their connections functionality and compensate the probable defects after fabrication. A digital circuit is designed to generate 4 non-overlapping clock signals to control the switches. In order to increase signal to noise ratio, the signal is converted from current to voltage mode using a capacitor and then amplified using two fully differential amplifiers. The capacitor is discharged every complete cycle to ensure linear functionality. Layouts of different blocks used in the project are designed and pre-layout and post-layout simulation results are gathered and presented. Simulation results show sensitivity of 8383 V/(A.mT) and power consumption of 36 uW, while using 3 uA as input bias current, 1.8 V as supply voltage, and consuming 6259 um2 of chip area.
Benzer Tezler
- Design of magnetic sensing microsystem with hall sensors
Hall algılayıcılı manyetik alan algılama mikrosistemi tasarımı
ECE OKTAY
Yüksek Lisans
İngilizce
2016
Elektrik ve Elektronik MühendisliğiBoğaziçi ÜniversitesiElektrik-Elektronik Mühendisliği Ana Bilim Dalı
PROF. DR. GÜNHAN DÜNDAR
YRD. DOÇ. DR. HAMDİ TORUN
- Nikel alaşımlı esnek filament nüveli Rogowski bobinin tasarımı ve geliştirilmesi
Design and development of Rogowski coil with nickel alloy flexible filament core
GİZEM MERVE AYDIN
Yüksek Lisans
Türkçe
2023
Elektrik ve Elektronik MühendisliğiDüzce ÜniversitesiElektrik-Elektronik Mühendisliği Ana Bilim Dalı
DOÇ. DR. EMİN YILDIRIZ
- Rüzgar hız ve yön algılayıcılarının tasarım ve geliştirilmesi
Design and development of wind speed and wind direction sensors
UĞUR KARAKAYA
Yüksek Lisans
Türkçe
2017
Enerjiİstanbul Teknik ÜniversitesiEnerji Bilim ve Teknoloji Ana Bilim Dalı
YRD. DOÇ. DR. BURAK BARUTÇU
- Design and implementation of a double-sided coreless linear motor
Çift taraflı hava çekirdekli lineer motor tasarımı ve gerçeklenmesiçift taraflı hava çekirdekli lineer motor tasarımı ve gerçeklenmesi
ÖZGE TAŞKIN
Yüksek Lisans
İngilizce
2015
Mekatronik Mühendisliğiİstanbul Teknik ÜniversitesiMekatronik Mühendisliği Ana Bilim Dalı
DOÇ. DR. ÖZGÜR ÜSTÜN
- Design, characterization, visualization and navigation of swimming micro robots in channels
Kanal içinde yüzen mikro robotların tasarımı, karakterizasyonu, görüntülenmesi ve navigasyonu
FATMA ZEYNEP TEMEL
Doktora
İngilizce
2013
Mekatronik MühendisliğiSabancı ÜniversitesiMekatronik Mühendisliği Ana Bilim Dalı
DOÇ. DR. SERHAT YEŞİLYURT