Geri Dön

Membran biyoreaktörlerde venturi enjektörü kullanılarak işletme şartlarının iyileştirilmesinin araştırılması

Investigation on the improvement of operating conditions by using the venturi injector in membrane bioreactors

  1. Tez No: 524541
  2. Yazar: GÖKMEN ÖZTÜRKMEN
  3. Danışmanlar: DOÇ. DR. NECATİ KAYAALP
  4. Tez Türü: Doktora
  5. Konular: Çevre Mühendisliği, İnşaat Mühendisliği, Environmental Engineering, Civil Engineering
  6. Anahtar Kelimeler: Venturi, membran biyoreaktör, kirlenme, havalandırma, Venturi, membrane bioreactor, fouling, aeration
  7. Yıl: 2018
  8. Dil: Türkçe
  9. Üniversite: Dicle Üniversitesi
  10. Enstitü: Fen Bilimleri Enstitüsü
  11. Ana Bilim Dalı: İnşaat Mühendisliği Ana Bilim Dalı
  12. Bilim Dalı: Belirtilmemiş.
  13. Sayfa Sayısı: 141

Özet

Atıksu arıtımında membran biyoreaktörlerin (MBR) kullanılmasının pek çok avantajı bulunmaktadır. Bunlar kısaca, daha kaliteli çıkış akımının sağlanması, daha az yer gerektirmesi, modüler olması ve daha az atık çamuru üretmesi olarak sıralanabilir. Bu avantajlarından dolayı MBR teknolojisinin uygulama alanları artmakta, kurulan tesislerin kapasitesi sürekli olarak gelişmekte ve bunların geliştirilmesine yönelik pek çok araştırma yapılmaktadır. Buna karşın MBR teknolojisinin çeşitli dezavantajları da bulunmaktadır. Atıksu arıtımında kullanılan membranların yüzey ve gözeneklerinin zamanla tıkanması, diğer bir deyişle membran kirlenmesi, MBR'lerin önemli dezavantajlarından biridir. Membranlar kirlendikçe sistemin enerji kullanım verimi düşmekte, dolayısıyla sistemin arıtma maliyetleri artmaktadır. Bu durum MBR'lerin işletme maliyetini önemli oranda arttırmaktadır. MBR'lerin en önemli dezavantajı olan membran kirlenmesini azaltmak için, daha az kirlenen membranların üretilmesi, yeni membran modüllerinin geliştirilmesi ve işletme şartlarının optimize edilmesi konusunda pek çok araştırma yapılmaktadır. Bu çalışmada laboratuvar ölçekli batık bir MBR'de yeni bir havalandırma şeklinin membran kirliliğini azaltma ve oksijen transfer verimini arttırmadaki etkinliği araştırılmıştır. Bu kapsamda batık bir MBR'ye bir venturi enjektörü entegre edilerek, gerekli havanın sisteme kendiliğinden girmesi sağlanmıştır. Venturi enjektörü sayesinde elde edilen jet akımı, membran yüzeyine yöneltilerek membran yüzeyinin daha etkili bir şekilde temizlenmesi amaçlanmıştır. Yapılan sentetik ve gerçek atıksu çalışmalarında, aynı hava miktarı venturi enjektörü ile sağlandığında MBR'deki çözünmüş oksijen konsantrasyonunun blower ile sağlanandan çok daha yüksek olduğu gözlenmiştir. Membran kirliliği çalışmalarından, aynı akı ve havalandırma hızında venturi enjektörü kullanılan sistemde transmembran basıncı (TMP) gelişim hızının çok daha düşük olduğu, sistem akısı arttıkça blower ve venturi havalandırma sistemleri arasındaki farkın daha çok arttığı gözlenmiştir. Buna paralel olarak, eşit şartlar altında venturi sisteminin çalışmada belirlenen maksimum çalışma TMP değerine blower sisteminden çok daha geç ulaştığı gözlenmiştir.

Özet (Çeviri)

There are many advantages of using a membrane bioreactor (MBR) in wastewater treatment. These advantages can be summarized as better effluent quality, less footprint, being modular and less waste sludge production. Due to these advantages, application fields and the installation capacity of MBR technology have been constantly increasing and numerous studies have been done to improve this technology. However, in addition to its advantages, MBR technology has important disadvantages. One of the most important disadvantages is the blocking of membrane pores and surface as it is being used, in other words, membrane fouling. As membranes become fouled, the energy utilization efficiency of the system drops; therefore, treatment cost of the system increases. When a specific fouling point is reached, the system should be shut down and the membranes are subjected to an intensive cleaning process. This case increases the operation cost of MBRs substantially. To mitigate the most important disadvantage of the MBRs, which is membrane fouling, a lot of research has been done in terms of production of less fouling membranes, development of new membrane modules and optimization of operating conditions. In this study, the effectiveness of a novel aeration method on membrane fouling reduction and on the improvement of oxygen transfer efficiency was investigated. In this scope, the required air was ensured to enter the system spontaneously by integrating a venturi injector to a submerged MBR. It is aimed to clean the membrane surface more efficiently by directing the jet flow through the venturi injector to the membrane surface. In studies performed with the synthetic and real wastewater, by supplying the same amount of air, it is observed that the oxygen concentration in MBR was very high compared to that supplied by the blower. Membrane fouling studies indicate that the with the same flux and aeration rate, transmembrane pressure (TMP) development is much lower in the venturi injector system at the same flow and aeration rate, and the difference between the blower and venturi aeration systems is observed to increase more as the system flow increases. In parallel to that under the same conditions, it was observed that the venturi system reached to the maximum TMP value later than the blower system. In parallel, comparing to the blower system, the venturi system, set under the same conditions, reached much later to the TMP value determined within the scope of this study.

Benzer Tezler

  1. Membran biyoreaktörlerde atıksulardan demir arıtımı

    Removal iron from wastewater in membrane bioreactors

    NEHİR GÜLER SAATÇIOĞLU

    Yüksek Lisans

    Türkçe

    Türkçe

    1998

    Çevre MühendisliğiAtatürk Üniversitesi

    Çevre Mühendisliği Ana Bilim Dalı

    DOÇ. DR. BÜLENT KESKİNLER

    YRD. DOÇ. DR. TURGAY PEKDEMİR

  2. Membran biyoreaktörlerde (MBR) tıkanma kontrolü için titreşim uygulamaları

    The vibration applications for fouling control of the membrane bioreactors (MBR)

    MERVE YILMAZ

    Yüksek Lisans

    Türkçe

    Türkçe

    2016

    Çevre Mühendisliğiİstanbul Teknik Üniversitesi

    Çevre Mühendisliği Ana Bilim Dalı

    PROF. DR. İSMAİL KOYUNCU

  3. Membran biyoreaktörlerde enerji ihtiyacının azaltılması ve membran yüzey temizleme işlemlerine değişik yaklaşımlar

    Reduction of energy consumption in mbr systems and different aproaches of membrane surface cleaning systems

    SEDAT SOYBAY

    Doktora

    Türkçe

    Türkçe

    2016

    Çevre Mühendisliğiİstanbul Teknik Üniversitesi

    Çevre Bilimleri Ana Bilim Dalı

    PROF. DR. İSMAİL KOYUNCU

  4. Batık membran biyoreaktörlerde (Mbr) eş zamanlı elektrofiltrasyon ve elektrokoagülasyon uygulamaları ile membran kirlenmesinin azaltılması

    Reduction of fouling in submerged membrane bioreactors by simoultaneous electrofiltration and electrocoagulation applications

    SEÇİL BAYAR

    Doktora

    Türkçe

    Türkçe

    2017

    Çevre MühendisliğiGebze Teknik Üniversitesi

    Çevre Mühendisliği Ana Bilim Dalı

    PROF. DR. AHMET KARAGÜNDÜZ

  5. Membran biyoreaktörlerde titreşim ile tıkanma kontrolü

    Fouling control of membrane bioreactors by vibration

    RECEP KAYA

    Doktora

    Türkçe

    Türkçe

    2018

    Çevre Mühendisliğiİstanbul Teknik Üniversitesi

    Çevre Mühendisliği Ana Bilim Dalı

    PROF. DR. İSMAİL KOYUNCU