Kompozit tabanlı alan etkili transistör tasarımı ve dokunsal algılama uygulaması
Composite based field effect transistor design and tactile sensing application
- Tez No: 759205
- Danışmanlar: DOÇ. DR. DİNÇER GÖKCEN
- Tez Türü: Yüksek Lisans
- Konular: Elektrik ve Elektronik Mühendisliği, Electrical and Electronics Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2022
- Dil: Türkçe
- Üniversite: Hacettepe Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Elektrik ve Elektronik Mühendisliği Ana Bilim Dalı
- Bilim Dalı: Elektrik Elektronik Mühendisliği Bilim Dalı
- Sayfa Sayısı: 116
Özet
Bu tez kapsamında nanokompozit yapılar kullanılarak esnek alan etkili transistör (FET) tasarım ve üretimine dair çalışmalar yapılmıştır. Alan etkilerinin gerçekleştiği tasarım topoloji olarak ince film transistörlere (TFT) benzer şekilde olup, işlevsel olarak esnek dokunsal sensör görevi görmektedir. Günümüz teknolojilerinde özellikle giyilebilir sistemlere artan ilgiyle doğru orantılı olarak esnek yapılara yönelim hızla artmaktadır. Elektronik aygıtların temel birimi olarak kabul gören transistörlerde bu gelişmeden nasibini almaktadır. Bu süreçte metal oksit yapılar kullanılarak alan etkili transistörler oluşturulma eğilimi artmıştır. Mekanik bir girdi olan, basınç ile değişen elektriksel değerler sensör çıktılarını oluşturuken, TFT dielektriği üzerindeki kanal genişliği değişmekte, buna bağlı olarak dokunma-akım gözlenmektedir. Deneyler öncesi hazırlanacak kompozitlerin karışım oranları ve iletkenlik bilgisi benzetim ortamında gerçekleştirilmiştir. Tez çalışması kapsamında oluşturulacak alan etkili transistörlerin, düşük maliyette ve sürdürülebilir kaynaklar ile kullanımı için materyal seçimi ve karşılaştırılması yapılmıştır. Buna ek olarak hızlı ve yaygın üretim için kolay elde edilebilir sistemler tercih edilmiş, üretime erişelebilirlik artılmak istenmiştir. Diğer birçok endüstriyel üretim basamakları açıklanmış, getirileri bahsedilmiştir. Ayrıca kanal genişliği ve birim hacimdeki FET sayısını optimize etmek için parametre çalışmaları gerçekleştirilmiştir. Bu FET'lerin kapı elektrotlarının karşılaştırılmasını yapmak adına grafen ve bakır elektrotlar tercih edilmiştir. Üretim sonrası doğrulama adına grafen elektrotların karakterizasyonu Raman spekstreskopisi ile sağlanmıştır. Oluşturulan grafen elektrotlar ile iki kat daha iyi kapasitif etki meydana gelmiştir. Elde edilen yarı iletken katmanlar sıcak-nokta probu yöntemiyle P veya N tipi olarak ifade edilmektedir. Taramalı elektron mikroskobu (SEM) ve atomik kuvvet mikroskobu (AFM) yardımıyla katkı partiküllerinin dağılımı yorumlanmıştır. Ardından elektriksel karakterizasyonları gerçekleştirilmiştir. Esnek algılama birimlerinin çıktılarından anlamlı veriler elde edebilmek adına makine öğrenmesi algoritmaları kullanılmıştır. Alttan kapılı, alttan kontaklı üretilen tasarımda, üçgen, yıldız, kare ve daire desenlerinin üç kolonlu sensör matris üzerine teması sonucu elde edilen verilerin sınıflandırılmasında %95 üzeri doğruluk değerlerine erişilmiştir.
Özet (Çeviri)
Studies on the design and production of flexible field-effect transistors (FET) using nanocomposite structures were carried out within the scope of this thesis. The design, on which field effects occur on it, is similar to thin-film transistors (TFT) in topology and had been used as a functionally flexible tactile sensor. In today's technologies, in direct proportion to the increasing interest in wearable systems, the tendency towards flexible structures is increasing rapidly. Transistors, which are accepted as the basic unit of electronic devices, have their share of this development. The tendency to create field effect transistors using metal oxide structures has increased in this process. While the electrical values change with the pressure, which is a mechanical input, from the sensor outputs, the channel width on the TFT dielectric changes, and accordingly touch-current relation is observed. The mixing ratios and conductivity information of the composites were prepared before the experiments were carried out in the simulation environment. Material selection and comparison have been made for the use of field effect transistors, which will be created within the scope of the thesis, with low cost and sustainable sources. In addition, homemade systems were preferred for fast and widespread production, and it was desired to increase accessibility to production. Many other industrial production steps are explained and their benefits are mentioned. In addition, parameter studies were carried out to optimize the channel width and the number of FETs per unit volume. In order to compare the gate electrodes of these FETs, graphene and copper electrodes were preferred. Characterization of graphene electrodes for post-production validation was achieved by Raman spectroscopy. With the created graphene electrodes, a two times better capacitive effect was achieved. The resulting semiconductor layers are expressed as P or N-type by the hot-point probe method. The distribution of additive particles was interpreted with the help of a scanning electron microscope and atomic force microscope. Then electrical characterizations were carried out. Machine learning algorithms were used to obtain meaningful data from the outputs of flexible sensing units. In the design produced with a bottom gate and bottom contact, accuracy values of over 95% have been reached in the classification of the data obtained as a result of the contact of triangle, star, square, and circle patterns on the sensor matrix.
Benzer Tezler
- Karbon tabanlı yeni hibrit nano-yapıların modellenmesi ve analizi
Modeling and analysis of carbon based new hybrid nano-structures
ÜNAL DEĞİRMENCİ
Doktora
Türkçe
2019
Makine Mühendisliğiİstanbul Teknik ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
DOÇ. DR. MESUT KIRCA
- Yeni sentez kobalt ftalosiyanin tabanlı organik transistör üretimi ve elektriksel karakterizasyonu
Fabrication and characterization of the OFET based on novel cobalt phthalocyanine containing alkyl chain
CİHAT İLİK
Yüksek Lisans
Türkçe
2017
Fizik ve Fizik MühendisliğiSakarya ÜniversitesiFizik Ana Bilim Dalı
DOÇ. SADIK BAĞCI
- Fabrication and characterization of new generation organic field effect transistors
Yeni nesil organik alan etkili transistörlerin üretimi ve karakterizasyonu
BETÜL CANIMKURBEY
Doktora
İngilizce
2017
Fizik ve Fizik MühendisliğiGebze Teknik ÜniversitesiFizik Ana Bilim Dalı
PROF. DR. SAVAŞ BERBER
PROF. DR. ZAFER ZİYA ÖZTÜRK
- Mechanical properties of boron nanotubes
Bor nanotüplerin mekanik özellikleri
ERDEM ÇALIŞKAN
Yüksek Lisans
İngilizce
2021
Makine Mühendisliğiİstanbul Teknik ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
DOÇ. DR. MESUT KIRCA
- Electrospun polyacrylonitrile based composite nanofibers containing polyindole and graphene oxide
Poliindol ve grafen oksit içeren poliakrilonitril tabanlı kompozit nanofiberler
İLKNUR BOZKAYA GERGİN
Doktora
İngilizce
2023
Polimer Bilim ve Teknolojisiİstanbul Teknik ÜniversitesiPolimer Bilim ve Teknolojisi Ana Bilim Dalı
PROF. DR. ABDÜLKADİR SEZAİ SARAÇ