Geri Dön

Effect of fiber and resin type on the axial and circumferencial tensile strength of fiber reinforced polyester pipe

Elyaf ve reçine tipinin elyaf takviyeli polyester borunun eksenel ve çembersel mukavemetine etkisi

  1. Tez No: 176825
  2. Yazar: NESLİHAN GÖKÇE
  3. Danışmanlar: PROF. DR. ÜLKÜ YILMAZER
  4. Tez Türü: Yüksek Lisans
  5. Konular: Bilim ve Teknoloji, Science and Technology
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 2008
  8. Dil: İngilizce
  9. Üniversite: Orta Doğu Teknik Üniversitesi
  10. Enstitü: Fen Bilimleri Enstitüsü
  11. Ana Bilim Dalı: Polimer Bilim ve Teknolojisi Ana Bilim Dalı
  12. Bilim Dalı: Belirtilmemiş.
  13. Sayfa Sayısı: 146

Özet

Bu çalışmada, amaç santrifüj savurma üretim yöntemi ile üretilmiş olan kısa elyaf takviyeli polyester kompozit borularının rijitlik, boyuna çekme dayanımı ve çembersel çekme dayanımının araştırılmasıdır. Bu amaca ulaşmak için, boruların elastisite modülünün teorik hesaplaması yapılmış ve daha sonra test programı ortoftalik, izoftalik, vinilester reçine olan üç farklı reçine tipi ve E cam elyaf, ECR cam elyaf, bazalt elyaf olan üç farklı elyaf tipi ile üretilen boru numuneleri üzerinde yürütülmüştür. Testler ISO'ya (Uluslararası Standardizasyon Organizasyonu) uygun olarak yapılmıştır.Reçine tipi ve elyaf tipinin elyaf takviyeli polyester boru numunelerindeki etkisi değerlendirildiğinde, hesaplanan elastisite modülü değerleri test sonuçlarını doğrulamıştır.Reçine tipinin elyaf takviyeli polyester boru üzerindeki etkisini değerlendirmek için kullanılan deneysel verilere göre, farklı reçine tiplerine sahip boruların rijitlik, boyuna çekme dayanımı ve çembersel çekme dayanımı test sonuçlarında kayda değer bir fark gözlenmemiştir. Sonuç olarak, reçine tipinin santrifüj savurma yöntemi ile üretilmiş olan kısa elyaf takviyeli polyester boruların rijitlik, boyuna çekme dayanımı ve çembersel çekme dayanımında kayda değer bir etkisi olmamıştır.Elyaf tipinin elyaf takviyeli polyester boru üzerindeki etkisini değerlendirmek için kullanılan deneysel verilere göre, bazalt elyaf takviyeli boru numuneleri E cam elyaf ve ECR cam elyaf takviyeli borulara göre daha yüksek performans göstermiştir. Fakat bazalt elyaf takviyeli polyester borularının bu test sonuçları bazalt elyafının özellikleri kadar iyi değildir.Son olarak, E cam elyaf takviyeli boru numuneleri ile hemen hemen aynı rijitlik ve çekme test sonuçlarına sahip bazalt elyaf takviyeli boru numuneleri kıyaslanarak elyaf ve reçine miktarındaki kazanç araştırılmıştır. Bazalt elyaf takviyeli borular E cam elyaf takviyeli borulardan daha hafif ve ince olmuştur. Fakat bazalt elyaf takviyeli borunun elyaf ve reçine miktarındaki azalma toplamda maliyet azalmasına yol açmamıştır.

Özet (Çeviri)

In this study, the aim is to investigate the stiffness, longitudinal tensile strength and circumferential tensile strength of short fiber reinforced polyester composite pipes produced by centrifugal casting production method. To achieve this aim, theoretical calculation of modulus of elasticity of pipes was done and then test program was carried out on pipe samples produced with three different resin types which were orthophthalic, isophthalic and vinyl ester resin and three different fiber types which were E glass fiber, ECR glass fiber and basalt fiber. The tests were performed according to ISO (International Organization for Standardization) standards.When resin type and fiber type effect on the fiber reinforced polyester pipe samples were evaluated, calculated elastic modulus values were in accordance with the test results.According to the experimental test data, which were used to evaluate the effect of resin type on fiber reinforced polyester pipe properties, there is not a significant difference was observed in the stiffness, longitudinal and circumferential tensile strength test results of pipes having different resin types. In other words, there was not a significant effect of resin type on the stiffness, longitudinal tensile strength and circumferential tensile strength of short fiber reinforced pipes produced by centrifugal casting method.According to the experimental test data, which were used to evaluate the effect of fiber type on the properties of fiber reinforced polyester pipe, basalt fiber reinforced pipe samples showed higher mechanical performance over E glass fiber and ECR glass fiber reinforced pipes. However, the test results of basalt reinforced polyester pipe were not as good as the individual properties of basalt fiber.Finally, by comparing the basalt fiber reinforced pipe samples having almost the same stiffness and tensile test results as E glass fiber reinforced pipe samples, the gain in fiber and resin amount were investigated. Basalt fiber reinforced pipes were slightly lighter and thinner than E glass fiber reinforced pipes. However, the decrease in the amount of the fiber and resin in basalt reinforced pipe did not result in an overall cost reduction.

Benzer Tezler

  1. Hibrit fiber kompozit malzemelerin mekanik özelliklerinin deneysel olarak incelenmesi

    Experimental investigation of mechanical properties of hybrid fiber composite materials

    FATİH EMİR DANYILDIZ

    Yüksek Lisans

    Türkçe

    Türkçe

    2023

    Makine MühendisliğiSakarya Üniversitesi

    Makine Mühendisliği Ana Bilim Dalı

    DOÇ. DR. SEÇİL EKŞİ

  2. LP sargılı beton için önerilmiş olan dayanım ve şekil değiştirme modellerinin farklı boyutlar üzerindeki performanslarının incelenmesi

    Investigation of the performance of proposed models of strength and strain for frp wrapped concrete on different sizes

    ALPER TURGUT

    Yüksek Lisans

    Türkçe

    Türkçe

    2021

    İnşaat Mühendisliğiİstanbul Teknik Üniversitesi

    İnşaat Mühendisliği Ana Bilim Dalı

    PROF. DR. ALPER İLKİ

  3. Betonarme kolonların deprem performansının tekstil donatılı / donatısız cam lifli püskürtme harçla iyileştirilmesi

    Improvement of seismic performance of reinforced concrete columns using glass fiber reinforced sprayed mortar with / without textile reinforcement

    ALİ OSMAN ATEŞ

    Doktora

    Türkçe

    Türkçe

    2022

    Deprem Mühendisliğiİstanbul Teknik Üniversitesi

    İnşaat Mühendisliği Ana Bilim Dalı

    PROF. DR. ALPER İLKİ

  4. Seismic retrofit of rc columns with basalt mesh reinforced sprayed grc: Effects of stirrup hook angle and hook length

    Betonarme kolonların basalt hasır donatılı püskürtme grc ile depreme karşı güçlendirilmesi: Etriye kanca açısı ve boyunun etkisi

    SAEID HAJIHOSSEINLOU

    Yüksek Lisans

    İngilizce

    İngilizce

    2014

    İnşaat Mühendisliğiİstanbul Teknik Üniversitesi

    İnşaat Mühendisliği Bölümü

    PROF. DR. ALPER İLKİ

  5. Deformation behavior of thin walled structures filled with auxetic and non-auxetic core materials

    Ökzetik ve ökzetik olmayan dolgu malzemeli ince cidarlı yapıların deformasyon davranışı

    FATİH USTA

    Doktora

    İngilizce

    İngilizce

    2021

    Uçak Mühendisliğiİstanbul Teknik Üniversitesi

    Uçak ve Uzay Mühendisliği Ana Bilim Dalı

    PROF. DR. HALİT SÜLEYMAN TÜRKMEN

    PROF. DR. FABRIZIO SCARPA