Geri Dön

Characteristics and use of a nonlinear end-fired array for acoustics in air

Başlık çevirisi mevcut değil.

  1. Tez No: 401444
  2. Yazar: ALİ ONUR AKAR
  3. Danışmanlar: DR. ANDRES LARRAZA, DR. BRUCE C. DENARDO
  4. Tez Türü: Yüksek Lisans
  5. Konular: Elektrik ve Elektronik Mühendisliği, Fizik ve Fizik Mühendisliği, Electrical and Electronics Engineering, Physics and Physics Engineering
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 2007
  8. Dil: İngilizce
  9. Üniversite: The Naval Postgraduate School
  10. Enstitü: Yurtdışı Enstitü
  11. Ana Bilim Dalı: Optik Mühendisliği Ana Bilim Dalı
  12. Bilim Dalı: Belirtilmemiş.
  13. Sayfa Sayısı: 82

Özet

Özet yok.

Özet (Çeviri)

The parametric array exploits two highly collimated ultrasound beams interacting in a given volume producing a single beam with very high directivity and almost no side lobes. The high directivity of the difference frequency signal of the parametric array is due to the interaction of the waves in the volume effectively producing a virtual end-fired array boosting pressure levels along the interaction region which is limited by the absorption coefficient. This thesis focuses on experiments conducted in an anechoic room using AS-18-B Audio Spotlight system from HolosonicTM. Furthermore, nonlinear theory was modeled by a linear discrete array. The beam pattern of the parametric loudspeaker, range dependence of primary and secondary signals and total harmonic distortion (THD) were measured and then compared to theory. Experimental data for the beam pattern of the parametric loudspeaker agreed with the theory. It was also shown that the parametric array had a very narrow beam width and almost no side lobes as opposed to conventional loudspeakers. Both primary waves and difference wave frequency signals were examined for their range dependence. Due to the complicated interference of the primary waves, it was impossible to compare experimental results with theoretical predictions. For the difference wave signals, experimental data was verified by theory, which was modified in order to accommodate both wave generation and the spreading region. Finally, THD of the parametric loudspeaker was measured for different amplitude modulation depths. Experimental results showed that preprocessing should be applied in order to decrease THD and achieve clean audio signal reproduction.

Benzer Tezler

  1. Novel cochlear electrode array development using microfabrication techniques

    Mikrofabrikasyon teknikleri kullanılarak yenilikçi koklear elektrot dizini geliştirilmesi

    GÜLÇİN ŞEFİYE AŞKIN

    Doktora

    İngilizce

    İngilizce

    2024

    Makine MühendisliğiHacettepe Üniversitesi

    Nanoteknoloji ve Nanotıp Ana Bilim Dalı

    DOÇ. DR. BİLSAY SÜMER

  2. Sürekli mıknatıslar ve mıknatıslayıcılar

    Başlık çevirisi yok

    BORA NALBANTOĞLU

    Yüksek Lisans

    Türkçe

    Türkçe

    1996

    Elektrik ve Elektronik Mühendisliğiİstanbul Teknik Üniversitesi

    PROF.DR. İLHAMİ ÇETİN

  3. Dinamik çarpma problemlerinde malzeme seçiminin önemi

    İmportance of the material selection in impact problems

    REYHAN UYAN ÖZSOYSAL

    Yüksek Lisans

    Türkçe

    Türkçe

    1994

    Gemi Mühendisliğiİstanbul Teknik Üniversitesi

    PROF.DR. ALİ İHSAN ALDOĞAN

  4. Esnek mekanizmaların tasarlanması ve kontrolü

    Design and control of compliant mechanisms

    AYŞE TEKEŞ

    Doktora

    Türkçe

    Türkçe

    2013

    Makine Mühendisliğiİstanbul Teknik Üniversitesi

    Makine Mühendisliği Ana Bilim Dalı

    DOÇ. DR. MEHMET SALIH DOKUZ

  5. A stress testıng framework for the Turkısh bankıng sector: an augmented approach

    Türk bankacılık sektörü için bir stres testi çerçevesi: Bir genişletilmiş yaklaşım

    BAHADIR ÇAKMAK

    Doktora

    İngilizce

    İngilizce

    2014

    BankacılıkOrta Doğu Teknik Üniversitesi

    İktisat Ana Bilim Dalı

    PROF. DR. NADİR ÖCAL