Geri Dön

Ekran baskı yöntemi ile metal oksit gaz sensörü fabrikasyonu

Metal oxide gas sensor factory with screen printing method

  1. Tez No: 470850
  2. Yazar: ELİF ŞAHİN
  3. Danışmanlar: YRD. DOÇ. DR. DEMET TATAR
  4. Tez Türü: Yüksek Lisans
  5. Konular: Bilim ve Teknoloji, Science and Technology
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 2017
  8. Dil: Türkçe
  9. Üniversite: Atatürk Üniversitesi
  10. Enstitü: Fen Bilimleri Enstitüsü
  11. Ana Bilim Dalı: Nanobilim ve Nanomühendislik Ana Bilim Dalı
  12. Bilim Dalı: Nanomalzeme Bilim Dalı
  13. Sayfa Sayısı: 66

Özet

Yarıiletken esaslı oksit malzemeler, gaz sensörlerinin imalatı için algılama malzemeleri olarak uzun yıllar kullanılmıştır. Yarıiletken gaz sensörlerinin yüzeyine getirilen yüklerin yoğunluğu çevredeki atmosferin bileşimine duyarlıdır. Bu nedenle, bu malzemeler farklı gazların tespiti için kullanılmıştır. SnO2, gaz sensörlerinin imalatı için temel malzeme olarak kullanılan en önemli metal oksit malzemelerinden biridir. Ayrıca La2O3,Fe2O3 gibi metal oksit yarıiletken malzemelerin de gaz sensör sistemine olan etkileri araştırılmıştır. Bu çalışmada yer alan sensörler oldukça basit ve ekonomik olan ve hiçbir teknolojik cihaz ve altyapı gerektirmeyen ekran baskı yöntemi ile elde edilmiştir. Kalın filmi kullanan teknoloji, alt tabakanın bir veya her iki tarafı üzerinde çok katmanlar üretebilir. Bunun, düşük maliyet, yüksek hassasiyet, kimyasal ve mekanik kararlılık gibi pek çok avantajı vardır. Bu nedenle, bu teknoloji kullanılarak gaz ortamında iyi algılama özelliklerine sahip düşük maliyetli SnO2, La2O3 katkılı SnO2 ve Fe2O3 katkılı SnO2 metal oksit gaz sensörleri üreterek yapısal, morfolojik ve sensör özellikleri incelendi.

Özet (Çeviri)

Semiconductor based oxide materials is used for many years as sensing requisites for the manufacture of gas sensors. Sensor of density of the loads brought to the area of the semiconductor gas sensors is sensitive to the composition of the surrounding atmosphere. For this reason, these requisites is used for the detection of different gases. SnO2 is one of the most significant metal oxide requisites used as the basic material for the production of gas sensors. Besides, the effects of metal oxide semiconducting requisites such as La2O3 and Fe2O3 on the gas sensor system were searched. The sensors included in this study were obtained by simple and economical screen printing method which does not require any technological device and infrastructure. The technology that uses thick film can produce multiple layers on one or both sides of the bottom layer. It has many advantages such as low expenditure, high precision, chemical and mechanical determination. For this reason, low cost SnO2, La2O3 doped SnO2 and Fe2O3 doped SnO2 metal oxide gas sensors with good sensing properties in the gas environment were obtained using this technology and structural, morphological and sensor properties were investigated.

Benzer Tezler

  1. Yeni mono ve bis ftalosiyaninlerin sentezi ve özelliklerinin incelenmesi

    Synthesis and investigation of properties of novel mono and bis phthalocyanines

    GÜLŞAH GÜMRÜKÇÜ

    Doktora

    Türkçe

    Türkçe

    2010

    KimyaYıldız Teknik Üniversitesi

    Kimya Ana Bilim Dalı

    PROF. DR. MAHMURE ÜSTÜN ÖZGÜR

  2. NiO ince film bazlı elektrokromik kaplama/cihaz tasarımı, hazırlanması ve karakterizasyonu

    Design, preparation and characterization of electrochromic coating/device based on NiO thin film

    GAMZE ATAK

    Doktora

    Türkçe

    Türkçe

    2017

    Fizik ve Fizik MühendisliğiHacettepe Üniversitesi

    Fizik Mühendisliği Ana Bilim Dalı

    DOÇ. DR. ÖZLEM DUYAR COŞKUN

  3. Fabrication of single-walled carbon nanotube transparent conductive thin films

    Geçirgen ve iletken tek duvarlı karbon nanotüp ince filmlerin hazırlanması

    FATMA ÇOLAK

    Yüksek Lisans

    İngilizce

    İngilizce

    2015

    Enerjiİstanbul Teknik Üniversitesi

    Enerji Bilim ve Teknoloji Ana Bilim Dalı

    PROF. DR. NİLGÜN YAVUZ

  4. Production and characterization of white light based on energy up conversion mechanisms in Yb+3,Nd+3,Tm+3 rare earth ions doped y2o3-sio2 nano-phosphor materials

    Yb+3,Nd+3,Tm+3 nadir toprak iyon katkili Y2O3-SiO2 nanofosfor malzemelerde üst enerji̇ dönüşüm mekanizmasına dayalı beyaz ışık üretimi ve karakterizasyonu

    HATUN ÇINKAYA YILMAZ

    Doktora

    İngilizce

    İngilizce

    2019

    Fizik ve Fizik Mühendisliğiİstanbul Teknik Üniversitesi

    Fizik Mühendisliği Ana Bilim Dalı

    PROF. DR. GÖNÜL ERYÜREK

  5. Beşinci metakarpal kırıklarının tedavisi için yeni bir yaklaşım geliştirilmesi

    Development of a new approach for the treatment of fifth metacarpal fractures

    LÜTFİYE CAYMAZ

    Yüksek Lisans

    Türkçe

    Türkçe

    2024

    BiyomühendislikSakarya Üniversitesi

    Biyomedikal Mühendisliği Ana Bilim Dalı

    DR. ÖĞR. ÜYESİ OSMAN İYİBİLGİN

    DOÇ. DR. LEVENT BAYAM