Tekerlekli bir askeri taşıt için otomatik yangın söndürme ve infilak bastırma sistemi tasarımı
Automatic fire suppression and extinguishing system design for a wheeled military vehicle
- Tez No: 485323
- Danışmanlar: PROF. DR. CEMAL BAYKARA
- Tez Türü: Yüksek Lisans
- Konular: Mekatronik Mühendisliği, Mechatronics Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2017
- Dil: Türkçe
- Üniversite: İstanbul Teknik Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Mekatronik Mühendisliği Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 77
Özet
Bu tezde Otomatik Yangın Söndürme ve İnfilak Bastırma Sistemi'nin bir askeri taşıt için tasarımı anlatılmıştır. Tez içeriğinde bu tip bir askeri taşıt için ne tip gereksinimler olduğu ve bunun tasarıma nasıl etkiler yarattığı irdelenmiş ve sistem mimarisi ortaya konulmuştur. Daha sonra da detaylı olarak sistem elemanlarının teknik özellikleri anlatılmıştır. Bu sistemin tasarımında en önemli kriter süre olarak değerlendirilebilir. Süre olarak ortaya konan 250 milisaniye gereksinimi personelin çıkabilecek bir yangına maruz kaldığı hallerde derisinde geri dönüşü olmayacak şekilde bir yanık olmasını önleyebilecek süredir. Ayrıca bu tip sistemlerde kullanılmaya başlanan FM200 kimyasal ajanı yangını söndürme konusunda etkin bir çözüm olarak yer alırken aynı zamanda personelin korunmasını ve zarar görmemesini sağlamaktadır. Mimari ortaya çıkmadan önce taşıtta birbirinden bağımsız kaç bölme olduğu ve bu bölmelerin içeriğinin ne olduğu tespit edildikten sonar hacme ve içindeki ekipmana göre optik alev dedektörü ve söndürücü ekipmana karar verilir. Sistem 2 ana gruba ayrılarak tasarlanır: Algılayıcılar ve Söndürücüler Askeri bir taşıt olduğu için Savaş ve Barış durumu olarak adlandırılan 2 farklı moda göre tasarım yapılmıştır. Savaş modunda tek bir optik alev dedektörünün dahi yangını tespit etmesi sistemin aktif olmasına ve yangını söndürmek için tüpleri aktif etmesine yeterli olurken, Barış modunda bir yangını en az 2 alev dedektörünün görmüş olması gerekmektedir. Bu tip bir sistemde yanlış alarma sebep olabilecek kaynakların sistemi istemsiz bir şekilde aktif edebilme ihtimali bulunmaktadır ancak sistemde kullanılan optik alev dedektörleri yanlış alarm konusunda sorunsuz bir çalışma ortamı sunmaktadır. Otomatik Yangın Söndürme ve İnfilak Bastırma Sistemi personelin ve taşıtın bekası için kritik öneme sahip bir sistem olmasından ötürü tasarlandıktan sonra taşıt üzerinde bu sistemin doğrulanması gerekmektedir. Tezde bu tip doğrulama işlemlerinin nasıl yapılması gerektiği tasarlanan sistem üzerinden tarif edilmiştir. Tasarlanan sistemde motor bölmesinde tespit sistemi olarak optik alev dedektörlerinin kullanılmasına ve bu bölme için etkin bir yangın söndürme performansı için 5 optik alev dedektörünün yeterli olacağına karar verilmiştir. Söndürücü ajanın ise toplam 10 farklı noktadan dağıtıcı nozullar ile ilgili noktalara püskürtülmesine karar verilmiştir. Motor bölmesi için 2 tüpün kullanıldığı bir yapı kurulmuş, bu yapı ile söndürme için tüplerden bir tanesi yetersiz kaldığı durumda ikinci tüpün de ateşlenerek sönmeyen yangını söndürme ihitmali ciddi oranda artırılmıştır. Personel bölmesinde ise nozulların kullanılmasının yerleşim açısından sorun yaratıyor olmasından ötürü yangın söndürme tüplerinin alt kısımlarına konumlandırılan deflektörler ile söndürücü ajanın direkt olarak yangın söndürme tüpü üzerinden dağıtılması sağlanmıştır. Personel bölmesinde toplam 3 adet yangın söndürme tüpü ve 5 adet optik alev dedektörü kullanılarak bu hacimde maksimum etkinlikte bir çözüm bulunmuştur. Daha fazla alev dedektörü ve tüp kullanılması halinde daha iyi bir korunma sağlanacak olmasına rağmen maliyetler efektif olmayan sonuçlara doğru ilerleyecektir.
Özet (Çeviri)
Ground military vehicles have always been known with their superior weapon systems. Eliminating enemy targets is always the most important aspect. Throughout history, military professionals sought to have good attacking properties while procuring ground military vehicles. Things are changing in recent years. Nowadays, evaluting ground vehicles are not only based on a vehicle's attacking abilities. Protecting a mission requires also the protection of the vehicle as well as the personnel. Ballistic systems are very important for the defence properties of a vehicle. On the other hand, suppression systems are constantly under development in order to protect the personnel and military vehicle as well. Automatic Fire Suppression and Extinguishing System handles the fire situations without human intervention. Fire remains among the greatest threats in a military vehicle which requires the designers pay more attention for it. Fire protection is an important area of concern during the design, development and deployment phases for all modern wheeled ground vehicles. There are definitely manual modes for redundancy and emergency but the main purpose is to be able to suppress or extinguish a fire to prevent damage to either personnel or equipment. Preventing fire in the early stages dramatically reduce the possibility of personnel death. This system possess the same importance when compared with the ballistics protection of the vehicle. In this study, a system technologically advanced is presented but the main concern was to provide a practical, lightweight and effective solution to an already known problem. Explosion protection of the personnel in crew compartment in ground military vehicles is a unique and difficult application with sophisticated requirements that must balance suppression characteristics with safety limits. There are two types of components in the system: Suppressors and Detectors. As for the detectors, there are two possible alternatives. They can either sense the thermal energy or can detect the ultraviolet and infrared range of light caused by fire. Light sensitive optical detectors have very quick response and can detect fire in 2-4 miliseconds. It is obvious that their response time is at its highest. Main trick in this technology is to be able to respond any kind of fire within miliseconds. Unfortunately using only infrared or ultraviolet sensors might lead to errors in slowly developing fire conditions. That is why, new type of optical detectors use both of these sensors to be able to identify different types of fire more effectively. Thermal wire is another type of detector which uses the heat energy to detect the fire. These are traditionally used in non-human environments and are slow to respond because it takes some time for the fire to build up heat energy sufficient to activate the thermal wires and send detection signal to control box. For military vehicles, this is a designer's decision to use either optical detectors or thermal wire. As for the suppressors, there are couple of alternatives at hand. In the past, Halon was being used most of the time to suppress fire. However, it is hazardous to human health although it can record quite fast suppression time. FM200 is Halon's replacement in the industry. It has slower suppression time but the mixture can be made in a way that can enable the suppression of fire and do not harm human health at the same time. Novec and aerosol are also evaluated for their suppression performances as well. Aerosol is mostly used for low volume areas and was not useful for this application. On the other hand, usage of Novec was performance-wise was a good solution but it was not preferred. Free volume in the crew compartment determines the amount of extinguishing agent that needs to be used in the system as well as number of extinguishing cylinders. Decision for the number of optical detectors came from analysis in 3D environment, sampling is applied to verify the results. Detection of fire is not only needed for suppressing fire but to do it in a safe manner so that crew was not affected. Sensors can differentiate the real fire conditions with other hydrocarbon signatures coming from other non-threatening sources. A set of optimization took place during the development phase to overcome false alarm situations especially for peace conditions. As for the distribution agent, the valve system below the cylinders plays the most critical role. This system that was used is quick to respond and releases the extinguishing agent effectively. Deflectors are used to enhance the capability to reach almost everywhere. This is a product that can be modified based on the layout of the vehicle so that dead spots and areas which might deter the performance can be eliminated. For powerpack compartment, defining the risky areas has utmost importance. In order to have a better suppression characteristic and faster suppression time, instead of using thermal wire, optical detectors are preferred. Distribution of the agent is performed with well-placed nozzles. In order to prevent problems in harsh and sandy conditions, these nozzles have caps as well. Fuel lines are also the most critical areas in terms of possible fire condtions. These lines if placed closely to the electric lines may pose as a sparkling point for a fire condition. Control unit is the heart of the system and provides the necessary feedback to user so that any type of malfunction can be detected before the operation. Microprocessor used helps reducing the response time and a well-designed cover for protection provides the user with a robust experience. Although this agent is completely harmless to human beings, concentration after releasing it for fire protection plays a vital role. High concentration for better suppression characteristics could lead to problems in the field if the air ventilation system is not working properly. In order to avoid this problem, concentration level after releasing the agent is set to around %10-12 initially and verified with the test results. Configuration and layout depends on the vehicle volume and component layout. Usually there are 2 main compartments: Powertrain compartment and personnel compartment. Detectors shall be placed so that they cover almost any volume in the vehicle to be able to provide best level of protection. There should not be any obstacles within the line of sight of the optical detectors. Although they are very sensitive to fire, obstacles within their sight might reduce the possibility to suppress the fire in 250 miliseconds. Testing of a fire suppression system is the last step to verify and validate the system's performance. Cup burner test is the most common method to see the results of system design characteristics. In this study, this test process is conducted to be able to see and observe the placement of the suppressors and detectors of the system. This test is combined with a gas concentration test to check several areas in the vehicle. It is important to note that since there are some development areas for better performance. Other than the prohibited Halon which needs to be replaced in older vehicles as well, FM200 is the most commonly used agent which can be used as a suppression agent for portable extinguishers as well. However, this aspect of the system still needs additional research for better suppression and distribution properties. Optical detectors have been developed to be able to reduce false alarm rates and better fire detection capabilities. In this study, UV-IR optical detectors are used however there are different types of optical detectors developed for better fire detection characteristics. Using smoke detectors in combination with optical detectors may be evaluated as well for different areas within the vehicle. These detectors still require further development to reduce false alarm rates and better protection of the powerpack compartment but especially crew compartment. Automatic Fire Suppression System demand in the military industry can be considered as a starting point for future local content development strategies. In this respect, localization of this system can be realized by establishing local opportunities in the market.
Benzer Tezler
- Altı tahrikli (6x6) askeri bir aracın silah atış pozisyonlarında ve arzide seyir halinde dinamik durumunun incelenmesi
Dynamical analysis of a six-wheeled vehicle at positions of firing and riding in terrain
CİHAN DEMİR
Doktora
Türkçe
2003
Makine MühendisliğiYıldız Teknik ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
PROF. DR. NECATİ TAHRANLI
- Yüksek hareket kabiliyetine sahip çok amaçlı tekerlekli bir askeri taşıtın tahrikli ön aksı için bağımsız süspansiyon tasarımı
Independent suspension design for the driven front axle of a high mobility multipurpose wheeled military vehicle
EGEMEN BAHAR
Yüksek Lisans
Türkçe
2019
Makine MühendisliğiDokuz Eylül ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
DR. ÖĞR. ÜYESİ MEHMET MURAT TOPAÇ
- Tekerlekli zırhlı aracın doğrusal matris eşitsizlikleri tabanlı H-sonsuz kontrolör ile aktif titreşim kontrolü
Active vibration control of wheeled armoured vehicle with H-infinity controller based on linear matrix inequalities
MUHAMMED FATİH ÇAKIR
Yüksek Lisans
Türkçe
2023
Makine MühendisliğiYıldız Teknik ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
DOÇ. DR. MERAL BAYRAKTAR
DOÇ. DR. HAKAN YAZICI
- Ride quality evaluation methods for off-road vehicles
Yol dışı taşıtlar için sürüş kalitesinin değerlendirme yöntemleri
HANDE TÜTÜNCÜ ÇALKAN
Yüksek Lisans
İngilizce
2022
Makine Mühendisliğiİstanbul Teknik ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
PROF. DR. ÖZGEN AKALIN
- Arkeolojik buluntular, betimleme sanatı ve yazılı kaynaklar ışığında Urartu Krallığı'nda tekerlekli taşıtlar
In the light of archaeological finds, representational art and written sources wheeled vehicles in Urartu Kingdom
BİLCAN GÖKCE
Doktora
Türkçe
2011
ArkeolojiYüzüncü Yıl ÜniversitesiArkeoloji Ana Bilim Dalı
YRD. DOÇ. DR. RAFET ÇAVUŞOĞLU