Geri Dön

Yoğunlaştırılmış nano parçacıklı PVT/FDM sistemin deneysel analizi

Experimental analysis of the concentrated PVT/ PCM system with nanoparticles

  1. Tez No: 518107
  2. Yazar: ABDULKADİR GÜNAYDIN
  3. Danışmanlar: DR. ÖĞR. ÜYESİ ALPER ERGÜN
  4. Tez Türü: Yüksek Lisans
  5. Konular: Enerji, Energy
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 2018
  8. Dil: Türkçe
  9. Üniversite: Karabük Üniversitesi
  10. Enstitü: Fen Bilimleri Enstitüsü
  11. Ana Bilim Dalı: Enerji Sistemleri Mühendisliği Ana Bilim Dalı
  12. Bilim Dalı: Enerji Sistemleri Mühendisliği Bilim Dalı
  13. Sayfa Sayısı: 90

Özet

Yenilenebilir enerji, günümüzde kullanılan fosil yakıt kaynaklarının bitecek olması ve enerji ihtiyacının sürekli artıyor olmasıyla gelecekte büyük öneme sahip olacaktır. Güneş enerjisi en önemli yenilenebilir enerji kaynaklarındandır. Güneş enerjisi kullanılarak elektrik üretimi yapılabilmektedir. Güneş enerjisinden elektrik üretme yöntemlerinden biri fotovoltaik (PV) sistemlerdir. Fotovoltaik sistemlerin veriminin artırılması için ışınımın arttırılması ya da panel arkası sıcaklığın düşürülmesi gerekmektedir. Bu bilgiler ışığında yapılan çalışmada yoğunlaştırıcı kullanılan üç panel deneysel olarak incelemiştir. Birinci panel normal bırakılarak sadece yoğunlaştırıcı kullanılmıştır. İkinci panel, panel arkası sıcaklığın azaltılması ve ısı depolama amaçlı faz değiştiren malzeme (FDM) ile doldurulmuştur. Üçüncü panelde ise faz değiştiren malzemeye %5 oranında nanopartikül (Al2O3) eklenmiştir. Böylece aynı şartlar altınca üç panelin termal ve elektriksel davranışları incelenmiştir. Ekserji analizi sonuçlarına göre nanopartikül parafin karışımlı panelin ortalama ekserji verimi %9,9 iken sadece parafin kullanılan panelin verimi %8,8 olarak tespit edilmiştir.

Özet (Çeviri)

Renewable energy will have great importance in future because of that the fossil fuel resources used today will be consumed and that the energy need increases continuously. Solar energy is one of the most important renewable energy sources. Electricity can be produced using the solar energy. One of the methods for generating electricity from the solar energy is photovoltaic (PV) systems. In PV systems solar radiation is absorbed and converted into the electricity. Greatest loss in PV systems is caused by the conversion of radiation into the thermal energy. For increasing the efficiency in PV systems, it is necessary to increase the radiation or to reduce the temperature of the back of the panels. According to this information, in this study three panels using concentrator have been investigated experimentally. First panel has been kept normally and only the concentrator has been used. The second panel was filled with phase changing material (PCM) for the purpose of decreasing the temperature of the back of the panel and heat storage. In the third panel, nanoparticle (Al2O3) at a rate of 5% was added into the phase changing material. Thus, the thermal and electrical behaviors of three panels were investigated under the same conditions. According to the results of the exergy analyses, average exergy efficiency of the panel with Np-paraffin mixture has been determined as 9.9%, whereas that of the panel with paraffin as 8.8%.

Benzer Tezler

  1. Nitrat tuzlarının termal enerji depolama kapasitesini geliştirmek için uçucu kül tabanlı nanokompozitlerin tasarımı

    Desing of fly ash based nanocomposites for improvement thermal energy storage capacity of the nitrate salts

    ELİF NİDA GÖKSU

    Yüksek Lisans

    Türkçe

    Türkçe

    2023

    EnerjiTOBB Ekonomi ve Teknoloji Üniversitesi

    Mikro ve Nanoteknoloji Ana Bilim Dalı

    DOÇ. DR. HATİCE DURAN DURMUŞ

  2. Time-resolved in-situ analysis of densification of nano boron carbide under superimposed electric and thermal fields with energy dispersive x-ray diffraction

    Eş zamanlı elektrik ve termal alanlar altında nano bor karbürün yoğunlaşmasının zamana bağlı enerji dağılımlı x-ışını kırınımı ile yerinde analizi

    HÜLYA BİÇER

    Doktora

    İngilizce

    İngilizce

    2016

    Seramik MühendisliğiRutgers, The State University of New Jersey-New Brunswick Campus

    Malzeme Bilimi ve Mühendisliği Ana Bilim Dalı

    PROF. DR. THOMAS TSAKALAKOS

  3. Numerical and experimental performance of concentrated solar collector with direct heat exchange using none-circulated nanofluid

    Devridaim olmayan nano-sıvı kullanarak doğrudan ısı değişimli yoğunlaştırılmış güneş kollektörünün sayısal ve deneysel performansı

    WAQAS SAAD AL-KHAZRAJI

    Yüksek Lisans

    İngilizce

    İngilizce

    2017

    Makine MühendisliğiTürk Hava Kurumu Üniversitesi

    Makine ve Uçak Mühendisliği Ana Bilim Dalı

    Assist. Prof. Dr. MOHAMED ELMNEFI

    Assist. Prof. Dr. AMAR HASAN HAMEED

  4. Zeytin pirinasının farklı fenoliklerle sıvılaştırılması, reçineleştirilmesi ve yeni nesil kompozit anotlarda kullanımının araştırılması

    Liquefaction and resinification of olive pomace with different phenolics and investigation of its usage in new generation composite anodes

    TUFAN SALAN

    Doktora

    Türkçe

    Türkçe

    2023

    BiyokimyaKahramanmaraş Sütçü İmam Üniversitesi

    Malzeme Bilimi ve Mühendisliği Ana Bilim Dalı

    DOÇ. DR. ERTUĞRUL ALTUNTAŞ

    PROF. DR. MEHMET HAKKI ALMA

  5. Doğrudan absorblamalı bir güneş enerjisi toplayıcının tasarımı ve performans değerlendirmesi

    Design and performance evaluation of a direct absorption solar collector

    İSMAİL PAÇACI

    Yüksek Lisans

    Türkçe

    Türkçe

    2021

    EnerjiEge Üniversitesi

    Güneş Enerjisi Ana Bilim Dalı

    DOÇ. DR. KORAY ÜLGEN