A field study on the comparison the manifacturing companies before and after the posivite real interest policy was put into effect
Başlık çevirisi mevcut değil.
- Tez No: 7925
- Danışmanlar: PROF. DR. İBRAHİM ÖZER ERTUNA
- Tez Türü: Yüksek Lisans
- Konular: Ekonomi, Economics
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 1987
- Dil: İngilizce
- Üniversite: Boğaziçi Üniversitesi
- Enstitü: Sosyal Bilimler Enstitüsü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 40
Özet
Özet yok.
Özet (Çeviri)
In this thesis, the financial structure and operating results of manufacturing companies before and after the positive real interest rate policy was put into effect are compared. This study ras conducted by way of analyzing the financial structure and operating results of manufacturing companies froia those two t isse periods. All required figures related with the operating results of these companies were obtained from Istanbul Chamber of Industry Periodicals dated October 1985 and 1984 and Financial Analysis book written by Cihangir Şasin - By using these figures, firstly the financial ratios that are used in financial analysis were calculated, and then these ratios were compared with each other by using statistical analysis methods. The findings of this study showed that in the aspect of financial structure, the difference between the two groups of saanuacturing cospsnies from those two time periods was significant-- V - The discriminant function,, mentioned in section 2.2.1, explains approximately 20% of the discrimination, leaving 80% unexplained, which means that there might be other independent variables that vouid effect the discriminant function. According to findings. it case out that var 4-Return to Equity, var 2-Euqity/Totai Asset and var 6-Return on Sales each can be accepted as a discriminator between the two groups of companies.According to coefficients of the above variables, it is understood that companies from Group Two use more equity than companies from Group One, thus they have higher Equity/Total Asset Ratio and smaller Return to Equity Ratio. Return on Sales Ratio is higher for Group One companies which aseans that since financial expenses became higher due to the increase in interest rates, Return on Sales Ratio has decreased. In the study, the following limitations were en countered. Under the facility of the given figures, only six ratios were calculated. The other ratios that would be used in the analysis are indicated in Appendix 1. The share holders' equity figures include revaluation adjustment which otherwise would have changed.the results. The selected 90 companies for each year were not the same in the four years which otherwise might have changed the results. Additionally, in the selection of dependent variables, Group Two companies were selected from the years of 1983 and 1984 which otherwise would also have changed the results of the study.- vi - We hope that the results obtained from this study may contribute to the understanding of financial analysis of the manufacturing companies,
Benzer Tezler
- Endüstri 4.0'da robotik ve eklemeli üretim teknolojilerinin farklı rekabet ve üretim senaryoları altında stratejik analizi
Strategic analysis of robotic machining and additive manufacturing technologies under different competition and production scenarios
İREM ÖZGEN
Yüksek Lisans
Türkçe
2019
Endüstri ve Endüstri Mühendisliğiİstanbul Teknik ÜniversitesiEndüstri Mühendisliği Ana Bilim Dalı
PROF. DR. SEÇKİN POLAT
- Üretim kaynakları planlaması (MRP II) ve yan sanayi maliyet analizi ve kontrolü sistemi
Manufacturing resources planning (MRPII) and vendor firms cost analysis and control system
SERKAN SANCAN
Yüksek Lisans
Türkçe
1997
Endüstri ve Endüstri Mühendisliğiİstanbul Teknik ÜniversitesiEndüstri Mühendisliği Ana Bilim Dalı
DOÇ. DR. TUFAN VEHBİ KOÇ
- Yalıtım malzemesi enjeksiyon süreci optimize edilmiş yeni bir buzdolabı kabini tasarımı
Designing a new refrigerator cabinet based on optimization of the insulation material injection
FIRAT AKAR
Yüksek Lisans
Türkçe
2015
Enerjiİstanbul Teknik ÜniversitesiEnerji Bilim ve Teknoloji Ana Bilim Dalı
PROF. DR. İLYAS BEDİİ ÖZDEMİR
- Design of a refrigerator cabinet based on solidification process of polyurethane foam flow
Katılaşma süreci olan poliüretan köpük akışına güre yeni bir buzdolabı kabini tasarımı
HAMED PAHLAVANI
Yüksek Lisans
İngilizce
2015
Kimyaİstanbul Teknik ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
PROF. DR. İLYAS BEDİİ ÖZDEMİR
- Yapay sinir ağları ve makine öğrenmesi ile otomobil satış tahmininin yapılması ve zaman serileri analizi ile karşılaştırılması
Forecasting automobile sales using artificial neural networks and machine learning and comparison with time series analysis
BEYZA KURTGERİ
Yüksek Lisans
Türkçe
2024
Endüstri ve Endüstri MühendisliğiSakarya ÜniversitesiEndüstri Mühendisliği Ana Bilim Dalı
DOÇ. DR. MERVE CENGİZ TOKLU