Estimation of the tire-road friction coefficient andstability control of the vehicle by steering right and theleft tires independently
Başlık çevirisi mevcut değil.
- Tez No: 802698
- Danışmanlar: YRD. DOÇ. DR. BASAR OZKAN
- Tez Türü: Doktora
- Konular: Mekatronik Mühendisliği, Mechatronics Engineering
- Anahtar Kelimeler: Estimation of tire-road friction coe cient, tire model, simulation, Control system, Vehicle yaw stability, Active steering control, Independent steering, Disturbance observer
- Yıl: 2021
- Dil: İngilizce
- Üniversite: İstanbul Okan Üniversitesi
- Enstitü: Lisansüstü Eğitim Enstitüsü
- Ana Bilim Dalı: Mekatronik Mühendisliği Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 133
Özet
Özet yok.
Özet (Çeviri)
ESTIMATION OF THE TIRE-ROAD FRICTION COEFFICIENT AND STABILITY CONTROL OF THE VEHICLE BY STEERING RIGHT AND THE LEFT TIRES INDEPENDENTLY Over the last two decades, the automotive industries have been aiming to develop more advanced driving assisting systems (ADAS) such as anti-lock braking system (ABS), electronic stability control system (ESC), and lane keeping assist system (LKA) to improve safety of the ground vehicles for saving lives and preventing injuries. Most of the ADAS systems are utilizing longitudinal and lateral tire forces to realize the desired handling characteristics and improve the stability of the vehicle. The utilized tire forces are dependent on the surface friction and the tire loads. The surface friction is the most important mechanism for generating the tire forces. The saturation limits of the forces vary on dierent road surfaces which have dierent coe cients of surface friction, and it has a negative impact on the performance of the active safety systems which have a control structure assuming a constant coe cient of surface friction. For example, these systems can not provide enough tire forces to stabilize the vehicle on icy roads because of the reduced saturation limits. Therefore, it is crucial to know or estimate the coe cients of the friction of the road surfaces to improve the performance of the active safety system. In the rst part of the thesis, the estimation methods for the coe cients of the surface friction are investigated and a new estimation technique based on the active independent steering control system (AISCS) that has independent front tire steering capability was proposed. The second part of this thesis focuses on enhancing the performance of the in troduced AISCS system. After investigating the bene ts of the AISCS, two new control structures were proposed to improve its yaw-rate performance. The rst one is based on the inverse Pacejka tire model to determine the required steering angles for both tires. The second one uses tire forces as feedback and combines a conventional yaw controller with disturbance observers to calculate required steering angles.
Benzer Tezler
- Intelligent traction control system design and road characteristic estimation by acoustic signal processing in electric vehicles
Elektrikli araçlarda akıllı çekiş kontrol sistemi tasarımı ve akustik sinyal işleme ile yol karakteristiğinin tahminlenmesi
DAĞHAN DOĞAN
Yüksek Lisans
İngilizce
2012
Mekatronik Mühendisliğiİstanbul Teknik ÜniversitesiMekatronik Mühendisliği Ana Bilim Dalı
YRD. DOÇ. DR. PINAR BOYRAZ
- Adaptive autonomous emergency braking system based on estimation of tire/road friction coefficient
Yol ve tekerlek arasındaki sürtünme katsayısının kestirimine dayalı uyarlamalı otonom acil frenleme sistemi
ABDULLAH ÖMER SEVİL
Yüksek Lisans
İngilizce
2019
Bilgisayar Mühendisliği Bilimleri-Bilgisayar ve Kontrolİstanbul Teknik ÜniversitesiKontrol ve Otomasyon Mühendisliği Ana Bilim Dalı
PROF. DR. İBRAHİM EKSİN
- Dynamic, parametric modeling of electric vehicles and estimation of mass and tire road friction coefficient
Elektrikli araçların dinamik ve parametrik modellenmesi, kütle ve sürtünme katsayısı tahmin edilmesi
CAN ÖZYURTLU
Yüksek Lisans
İngilizce
2017
Mekatronik MühendisliğiOkan ÜniversitesiOtomotiv Mekatroniği ve Akıllı Araçlar Ana Bilim Dalı
PROF. DR. ORHAN BEHİÇ ALANKUŞ
- ABS fren dinamiği için çoklu model geçişli kontrolcü ve gözlemci tasarımı
Design of multi model switching controller and observer for ABS braking dynamics
MORTEZA DOUSTI
Yüksek Lisans
Türkçe
2014
Makine MühendisliğiHacettepe ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
YRD. DOÇ. DR. S. ÇAĞLAR BAŞLAMIŞLI
- Tekerlek yol sürtünme katsayısı için gözetleyici tasarımı
Observer design for tire road friction
MÜMİN AKTAŞ
Yüksek Lisans
Türkçe
2008
Elektrik ve Elektronik Mühendisliğiİstanbul Teknik ÜniversitesiMekatronik Mühendisliği Ana Bilim Dalı
PROF. DR. LEVENT GÜVENÇ