Hydrodynamics and heat transfer in gas-driven liquid film flows
Başlık çevirisi mevcut değil.
- Tez No: 402331
- Danışmanlar: PROF. DR. PETER STEPHAN, DR. TATIANA GAMBARYAN-ROISMAN
- Tez Türü: Doktora
- Konular: Biyoteknoloji, Kimya Mühendisliği, Biotechnology, Chemical Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2015
- Dil: İngilizce
- Üniversite: Technische Universität Darmstadt
- Enstitü: Yurtdışı Enstitü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 226
Özet
Özet yok.
Özet (Çeviri)
In many technical applications such as cooling systems used in chemical industry and fuel injection systems of modern gas turbines, thin liquid films driven by gravity or turbulent gas stream can be found. Since the thermo-hydrodynamic process in such liquid-gas flow configuration is rather complex, the transport mechanisms are not well understood. However, numerical simulations or theoretical models rely on these mechanisms. Experimental investigations are necessary in order to delineate this complex thermo-hydrodynamic phenomenon and to provide validation data to the theoreticians. The main objective of this work is to study the hydrodynamics and convective heat transfer in gravity and gas-driven thin liquid films on uniformly heated walls. To achieve this, an experimental set-up has been designed and measurements were performed in a flow channel. The liquid film was annularly applied on a vertically mounted heated tube. In the arranged two-phase flow domain, both fluids were thermally and hydrodynamically developing. The Reynolds numbers of liquid and gas flows were varied between 80 800 and 104 105, respectively. The wall heat flux was kept constant at 15Wcm2. The gas velocity profile in the flow channel was measured with hot-wire anemometry to determine the shear stresses on the dry wall surface. The effect of surface topography of the wall was investigated. The hydrodynamics and heat transfer of gas-driven liquid films was studied on micro-structures heated tubes. The dynamics of the liquid film flow was recorded by high-speed shadowgraphy technique. Using the high-speed images, the wave amplitudes and wave frequencies were determined. A high-speed infrared camera was used to qualitatively visualize the film rupture on micro-structured surfaces. The wall temperature distribution in streamwise direction was measured using thermocouples embedded inside the heated wall. Correlations for Nusselt number at unstructured surfaces have been proposed. This study reveals that the action of shear stress at a thin liquid layer flowing along an unstructured wall has a remarkable influence on the stability of the liquid-gas interface. Disturbances at the liquid film surface appear as the shear stress reaches a critical value. Measurements at various axial locations show that the fluctuations grow in the flow direction. The rate of growth is determined by the gas and liquid mass flow rates. With the increase in liquid Reynolds number, the liquid free-surface deformation is suppressed and the temporal film thickness fluctuations in the flow direction either decrease slightly or remain constant. A significant enhancement in heat transfer happens when the shear stress at the liquid-gas interface increases. However, there exists a threshold level of shear stress, only beyond which this is true. This exists as identified by comparing the experimentally determined heat transfer coefficients with the solutions of the classical Graetz-Nusselt model. Furthermore, the Nusselt numbers are compared with the Nusselt numbers of laminar, hydrodynamically and thermally developed falling films, falling films which develop thermally and those which are in the transition regime from laminar to turbulent flow, and with a turbulence model used from the literature. The comparison shows, that above gas Reynolds numbers larger than 7 · 104, the heat transfer coefficient is following the trend predicted by the turbulence model. Micro-structures have significant influence on the waviness of gas-driven liquid films. With increasing shear stress and liquid mass flow rate, the film waviness increases. Especially micro-structures embossed with obstacles normal to the flow direction lead to large wave amplitudes and high wave frequencies at low shear stress compared to the unstructured surface and the surfaces, incorporating structures oriented parallel to the flow direction. At low liquid mass flow rates and high shear stress, the area of local film rupture increases. Furthermore, micro-structures significantly enhance the heat transfer compared to the unstructured surface. Especially micro-structures combined by longitudinal and horizontal geometries are very effective in heat transfer enhancement at low shear stress and comparably low liquid mass flow rates.
Benzer Tezler
- Investigations into the evolution of heated liquid films
Isıtılan sıvı filmlerin evrimine ilişkin araştırmalar
OMAIR A. A. MOHAMED
Doktora
İngilizce
2024
Makine Mühendisliğiİhsan Doğramacı Bilkent ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
Assoc. Prof. LUCA BİANCOFİORE
- Eksenel gaz türbini kanat ucu geometrisinin hesaplamalı akışkanlar dinamiği ile aerotermal tasarımı
Aerothermal design of axial gas turbine blade tip using computational fluid dynamics
CEM BERK ŞENEL
Yüksek Lisans
Türkçe
2016
Makine Mühendisliğiİstanbul Teknik ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
YRD. DOÇ. DR. LEVENT ALİ KAVURMACIOĞLU
- A study on hydrodynamics and heat transfer in a bubble column reactor
Kabarcıklı kolon reaktöründe hidrodinamik ve ısı transferi çalışmaları
NİGAR KANTARCI
Yüksek Lisans
İngilizce
2003
Kimya MühendisliğiBoğaziçi ÜniversitesiKimya Mühendisliği Ana Bilim Dalı
PROF. KUTLU ÜLGEN
PROF. FAHİR BORAK
- Kimyasal buhar biriktirme yöntemi ile volfram çekirdekli bor fiber üretiminde sistem tasarımı
System design in tungsten-cored boron fiber production by chemical vapor deposition
SELİM ERTÜRK
Doktora
Türkçe
2012
Metalurji Mühendisliğiİstanbul Teknik ÜniversitesiMetalurji ve Malzeme Mühendisliği Ana Bilim Dalı
PROF. DR. İSMAİL DUMAN
- Experimental and numerical investigation of single and multiple droplet interactions with high-temperature surfaces
Yüksek sıcaklığa sahip yüzeylerde tek ve çoklu damlacık etkileşimlerinin deneysel ve sayısal incelenmesi
AHMET GÜLTEKİN
Doktora
İngilizce
2021
Enerjiİstanbul Teknik ÜniversitesiEnerji Bilim ve Teknoloji Ana Bilim Dalı
PROF. DR. ÜNER ÇOLAK