Effects of the surrounding environment on the buckling behaviour of columns
Başlık çevirisi mevcut değil.
- Tez No: 47542
- Danışmanlar: PROF.DR. GÜLAY A. ALTAY
- Tez Türü: Yüksek Lisans
- Konular: İnşaat Mühendisliği, Civil Engineering
- Anahtar Kelimeler: Eksenel yük, Lifler, Axial load, Fibers
- Yıl: 1995
- Dil: İngilizce
- Üniversite: Boğaziçi Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: Belirtilmemiş.
Özet
ÖZET Bu çalışmada fada şekil değişimine izin vermeyen ortamlarda bulunan ve kolon olarak modellenen yapısal elemanların burkulması araştırılmıştır. Bu amaçla bileşik malzemelerde ana yük taşıyıcı eleman olan fiberlerin eksenel basınç altındaki davranışı incelenmiştir. Bileşik malzemeden ayrılarak burkulması incelenen bir fiber için, diğer fiberlerin ve matris malzemesinin bir ortam oluşturduğu kabul edilmiştir. Fiber miktarı değiştirilerek farklı mekanik özellikte ortamlar tanımlanmıştır. Bu ortamlar tek boyutlu ve iki boyutlu yöntemler ile incelenerek, fiber yanal yüzeyindeki normal gerilmeler ile kayma gerilmeleri hesaplanmıştır. Her ortam için farklı miktarda olan bu gerilmeler burkulma denklemlerinde kullanılarak, ortamın fiber burkulmasını nicelik ve nitelik olarak ne şekilde etkilediği araştırılmıştır. İki boyutlu yöntemler kullanılarak hesaplanan burkulma yükleri, tek boyutlu yöntemler kullanılarak hesaplanan yüklerden daha düşük olduğu görülmüştür. Ortam tarafından sağlanan yanal desteğin yanısıra, kolon uçlarındaki desteklerin kritik burkulma yüküne olan etkileri incelenmiştir. Ortamın kolona sağladığı destek sebebi ile uçların tümüyle tutulu olmasının veya basitçe desteklenmiş olmasının, burkulma yükünü çok fazla değiştirmediği görülmüştür. Kolon uçları klasik destekler yerine elastik yaylar kullanılarak modellenmiş ve burkulma denklemleri farklı yay sabitleri için çözülmüştür. Kolon uçlarının farklı ortamlarda ne şekilde davrandığı incelenmiştir.
Özet (Çeviri)
IV ABSTRACT In this study, the buckling of columns in environment which allows small deformations is investigated. For this purpose, the composite materials are used to define the environmental effects. The axialry compressed fiber which is modeled as column is isolated from the composite material. It is accepted that the remaining fibers and the matrix material form an elastic environment for the fiber. Different environmental properties are obtained by changing the percentage of the fibers in composite material. The environment is analyzed by using one-dimensional (1-D) and two-dimensional (2-D) methods to understand the effects of the modeling. The normal stresses and the shear stresses on the lateral surface of the fiber are calculated according to the deformations in the environment. Then, these stresses are introduced into the buckling equation by statically equivalent forces and moments. The flexibility of the environment in 2-D is higher than those of 1-D. For this reason, the buckling loads calculated from 2-D methods are lower than 1-D counterparts. The environment does not only increase the load carrying capacity of the fiber, but also causes different buckling modes. In this study, the mode transition is investigated in detail by using extensional and rotational springs for the modeling of the environment. In addition to the lateral support supplied by the environment, the effects of the end supports on the critical buckling load are investigated. The comparison of different end conditions shows that the lateral support supplied by the environment decreases the end effects drastically. Instead of employing conventional end supports, pointwise springs are used for the modeling of the column ends. From the solution of the buckling equation for different spring stiffnesses, it is seen that the stiffness of the ends increases with an increase in the stiffness of the environment.
Benzer Tezler
- İki parametreli zemine oturan betonarme yapıların doğrusal olmayan hesabı ve görsel tabanlı bir bilgisayar yazılımı
Nonlinear analysis of reinforced concrete structures on two-parameter soil model and visual computer software
ONUR AVCIOĞLU
Doktora
Türkçe
2015
İnşaat Mühendisliğiİstanbul Teknik Üniversitesiİnşaat Mühendisliği Ana Bilim Dalı
PROF. DR. ENGİN ORAKDÖĞEN
- Effects of the physical environment on fear of crime and self-protective behaviors through city parks
Fiziksel çevrenin suç korkusu ve suça karşı kendini koruma davranışlarına etkilerinin şehir parkları üzerinden değerlendirilmesi
GİZEM CİHANLI
Yüksek Lisans
İngilizce
2023
Şehircilik ve Bölge Planlamaİstanbul Teknik ÜniversitesiKentsel Tasarım Ana Bilim Dalı
YRD. DOÇ. DR. İSMAİL EREN KÜRKÇÜOĞLU
- Hipoosmolar ortamın immün sistem üzerine olan etkileri
The effects of the hypoosmolar environment on the immune system
HALİL İBRAHİM DEMİR
Yüksek Lisans
Türkçe
2023
Allerji ve İmmünolojiBursa Uludağ Üniversitesiİmmünoloji Ana Bilim Dalı
PROF. DR. FERAH BUDAK
- Kumalar Çayı (Dinar) havzasının doğal ortam özelliklerinin beşeri ve ekonomik coğrafyaya etkisi
The effects of the natural environment features of the Kumalar River (Dinar) basin on human end economic geography
LÜTFİYE POSTALCI
Yüksek Lisans
Türkçe
2019
CoğrafyaAfyon Kocatepe ÜniversitesiCoğrafya Ana Bilim Dalı
DOÇ. DR. FATMA KAFALI YILMAZ
- Atrofik total dişsiz maksillada kullanılan titanyum ve peek materyalinden üretilmiş farklı subperiosteal implant tasırımlarının çevre dokulardaki biyomekanik etkilerinin sonlu elemanlar analizi kullanılarak incelenmesi
Investigation of the biomechanical effects of different subperiosteal implant designs made of titanium and peek materials used in atrophic total edentulous maxilla on the surrounding tissues using finite element analysis
TURGAY KASAP
Diş Hekimliği Uzmanlık
Türkçe
2024
Diş HekimliğiHacettepe ÜniversitesiAğız, Diş ve Çene Cerrahisi Ana Bilim Dalı
DOÇ. DR. MUSTAFA YİĞİT SAYSEL