Heat tarnsfer in falling film evaporators
Başlık çevirisi mevcut değil.
- Tez No: 50802
- Danışmanlar: PROF.DR. FİRUZ BALKAN
- Tez Türü: Yüksek Lisans
- Konular: Makine Mühendisliği, Mechanical Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 1996
- Dil: İngilizce
- Üniversite: Ege Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 56
Özet
Özet yok.
Özet (Çeviri)
Ill SUMMARY The variation of the heat transfer coefficients in a falling film evaporator at which evaporation takes place from the surface of the liquid films flowing down the inside surface of the vertical tube was investigated in this study. The experimental data were compared with the existing heat transfer data in the literature. As test fluids, distilled water and sodium hydroxide solutions at different concentrations (10% and 20%) were used. Test section which has a length of 500 mm. was heated by means of high current transformatör which supplies an alternative current of 275 A. Surface temperatures were measured at 8 different locations by means of“NiCr -Ni ”tliermocouples. hi the experiments performed by water and 10% sodium hydroxide solution the flow regime was turbulent and in experiments performed by 20% sodium hydroxide solution flow regime was laminar. The Reynolds Number ranged from 1 800 to 10 300, PrandÖ Number ranged from 1.76 to 4.625 and the heat flux applied to the tube wall was at the range of 12 255 to 12.690 W/m2. From the results it was seen that the thermal development length persisted up more than one half of the heated length for all the liquids tested, heat transfer coefficients were compared to each other and new correlations were developed. According to this comparison it was determined that for water and 10% sodium hydroxide solution the following correlation was used : h* = 0.003 Re 038Pr092 This is very close to the correlation that was recommended by Mudawwar. For the experiments performed by 20% NaOH which was in laminar regime, developed correlation was close to that was obtained by Chun and Seban and it was found to be, h*= 0.66 (Re/4)-023
Benzer Tezler
- Düşey film evaporatörlerde tasarım geometrisinin etkin akış dağılımı üzerine etkilerinin incelenmesi
Investigation of the effects of design geometry on effective flow distribution in falling film evaporators
EKİN CAN DOLGUN
Yüksek Lisans
Türkçe
2021
EnerjiGazi ÜniversitesiEnerji Sistemleri Mühendisliği Ana Bilim Dalı
PROF. DR. MUSTAFA AKTAŞ
- Dikey borulu buharlaştırıcılarda düşme yüksekliğinin ısı geçişiyle olan ilişkisinin deneysel araştırılması
Experimental reseach of relation of falling elavation in vertical tube evaporator with heat transfer
HÜSEYİN PEHLİVAN
Doktora
Türkçe
2008
Mühendislik BilimleriSakarya ÜniversitesiMakine Mühendisliği Bölümü
YRD. DOÇ. DR. MUSTAFA ÖZDEMİR
- Isı borusu prensibinin güneşli su ısıtıcılarına ve damıtmaya uygulanması
Başlık çevirisi yok
ALİ YÜCEL UYAREL
- Effect of frost formation on heat transfer: Experimental investigation and numerical model development
Karlanmanın ısı transferi üzerindeki etkisi: Deneysel inceleme ve sayısal model geliştirme
ALPER SAYGIN
Yüksek Lisans
İngilizce
2023
Makine MühendisliğiÖzyeğin ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
DR. ALTUĞ MELİK BAŞOL
PROF. DR. MEHMET ARIK