Investigation of the optical properties of Cu2ZnSnSe4 and detection of the secondary phases in Cu2ZnSnSe4 solar cell absorbers by spectroscopic ellipsometry
Başlık çevirisi mevcut değil.
- Tez No: 508171
- Danışmanlar: Prof. Dr. JURGEN PARISI
- Tez Türü: Doktora
- Konular: Elektrik ve Elektronik Mühendisliği, Enerji, Electrical and Electronics Engineering, Energy
- Anahtar Kelimeler: CZTSe quaternary compound semiconductor (SC), unwanted secondary phases, spectroscopic ellipsometry (SE), optical model
- Yıl: 2017
- Dil: İngilizce
- Üniversite: Carl von Ossietzky Universität Oldenburg
- Enstitü: Yurtdışı Enstitü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 83
Özet
Özet yok.
Özet (Çeviri)
The interest in quaternary compound semiconductor (SC) Cu2ZnSn(S,Se)4 (CZTSSe) has been rapidly increasing as an alternative absorber to the current thin film technologies. Their direct band gap and high absorption coefficient (>10-4 cm-1) make them a good candidate in solar cell technology. The band gap of CZTSSe compound SC is varying from 1.5 eV (pure S-based Cu2ZnSnS4) to 1.0 eV (pure Se-based Cu2ZnSnSe4). The band gap tunability of this material is also beneficial for multi-junction technology. Besides, lower toxicity and higher earth abundance, these are also promising for low cost and clean solar cell technology. However, the chemical and electronic nature of this material is challenging, i.e. co-existence of undesired secondary phases, band gap fluctuations, open circuit voltage Voc-deficit, low short circuit current density Jsc, etc.. The aim of this thesis is based on three motivations; the first one is the investigation of the optical properties of CZTSe absorber, and the second one is the identification of the secondary phases with finding their locations in CZTSe absorber and the last one is that these two steps should be done by a non-destructive tool. Therefore, Spectroscopic Ellipsometry (SE) was applied for all examined CZTSe absorbers and the MoSe2 sample as a main characterization tool since SE is a powerful technique to characterize the optical properties of a thin film. For SE data analysis, different optical model approaches were discussed with their results.
Benzer Tezler
- I2-II-IV-VI4 nanokristal bileşik yarıiletken ince filmlerin yapısal ve optik özelliklerinin incelenmesi
Investigation of structural and optical properties of I2-II-IV-VI4 nanocrystalline compound semiconductor thin films
ZEYNEP KİŞNİŞCİ
Doktora
Türkçe
2018
Fizik ve Fizik MühendisliğiSelçuk ÜniversitesiFizik Ana Bilim Dalı
DOÇ. DR. ÖMER FARUK YÜKSEL
PROF. DR. NİHAT TUĞLUOĞLU
- Deposition of Cu-Zn-Sn-Se (CZTSe) thin films and investigation of their device properties
Cu-Zn-Sn-Se (CZTSe) ince filmlerinin üretilmesi ve aygıt özelliklerinin belirlenmesi
ÖZGE BAYRAKLI
Doktora
İngilizce
2018
Fizik ve Fizik MühendisliğiOrta Doğu Teknik ÜniversitesiFizik Ana Bilim Dalı
PROF. DR. MEHMET PARLAK
- Cu2ZnSnS4 (CZTS) tabanlı ince film güneş hücrelerinde film homojenliğinin hücre verimi üzerindeki etkisinin incelenmesi
Investigation of effects of the film homogeneity on the cell efficiency of Cu2ZnSnS4 (CZTS) based thin film solar cell
MEHMET ALİ OLĞAR
Doktora
Türkçe
2017
Fizik ve Fizik MühendisliğiKaradeniz Teknik ÜniversitesiFizik Ana Bilim Dalı
PROF. DR. EMİN BACAKSIZ
PROF. DR. LÜTFİ ÖZYÜZER
- Synthesis of ZnO and Si nanowires for the fabrication of 3rd generation solar cells
Üçüncü nesil güneş pillerinin üretimi için ZnO ve Si nanotellerin sentezlenmesi
ELİF PEKSU
Doktora
İngilizce
2019
Fizik ve Fizik Mühendisliğiİstanbul Teknik ÜniversitesiFizik Mühendisliği Ana Bilim Dalı
DOÇ. DR. HAKAN KARAAĞAÇ
- Growth of cu2znsns4 absorber layer on flexible metallic substrates for thin film solar cell applications
İnce film güneş pili uygulamaları için Cu2ZnSnS4 soğurucu katmanının esnek metalik alttaşlar üzerinde büyütülmesi
ŞEBNEM YAZICI
Yüksek Lisans
İngilizce
2014
Bilim ve Teknolojiİzmir Yüksek Teknoloji EnstitüsüFizik Ana Bilim Dalı
DOÇ. DR. GULNUR AYGUN OZYUZER