Vanadium-transition metal oxide alloy thin films for microbolometer applications
Başlık çevirisi mevcut değil.
- Tez No: 518937
- Danışmanlar: Prof. DAVID L. ALLARA
- Tez Türü: Yüksek Lisans
- Konular: Metalurji Mühendisliği, Metallurgical Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2011
- Dil: İngilizce
- Üniversite: The Pennsylvania State University
- Enstitü: Yurtdışı Enstitü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 97
Özet
Özet yok.
Özet (Çeviri)
In this thesis, transition metal oxides were added in vanadium oxide films for microbolometer applications by co-sputtering. Vanadium and transition metals were sputtered with pulsed DC and RF power, respectively. Concentration of the metals in VOX films were determined by XPS and RBS techniques. Electrical and structural properties of the resulted films were analyzed with TCR, resistivity, TEM, Raman and GIXRD measurements. In general, TCR and resistivity values for alloying less than 10% were found to be similar to non alloyed films. Crystallinity of the films was found to be increased by addition of transition metal oxides. This study of alloying VOX films revealed that even with concentrations between 17-30 % transition metal oxides, VOX films grow with the same structural property which is a two phase system of nanocrystalline FCC domains surrounded by an amorphous matrix. ALD process with VTIP and H2O precursors was tried to produce VOX films. TCR and resistivity values for the resulted film were found to be -4.7%/K and 77 kOhm-cm, respectively. Mass per cycle data was collected using in-situ QCM, and layer by layer growth was observed. Growth per cycle for VTIP precursor for the conditions used in this thesis was found to be 0.32 Å/cycle.
Benzer Tezler
- AZ91 Mg alaşımlarının korozyon ve aşınma dayanımını artırmak için geçiş elementi metal nitrürleriyle kaplamalarının incelenmesi
Investigation of transition metal nitride coatings to improve the corrosi̇on and wear resistance of AZ91 Mg alloys
MERVE ERTAŞ USLU
Doktora
Türkçe
2016
Fizik ve Fizik MühendisliğiGebze Teknik ÜniversitesiFizik Ana Bilim Dalı
DOÇ. DR. LEYLA ÇOLAKEROL ARSLAN
- Yeni yönetmeliklere göre gıdalarla temasa uygun emaye yüzeylerin geliştirilmesiyeni
Development of food contact safe enamel surfaces according to the new regulations
GİZEM KADAKAL
Yüksek Lisans
Türkçe
2016
Metalurji Mühendisliğiİstanbul Teknik ÜniversitesiMalzeme Bilimi ve Mühendisliği Ana Bilim Dalı
PROF. DR. ONURALP YÜCEL
- Taban malzeme ile emaye kaplama arasındaki difüzyon mekanizmasının araştırılması ve düşük metal migrasyonuna sahip emaye geliştirilmesi
Investigation of diffusion mechanisms at substrate enamel interface and development of new enamel surface with low metal migration
ÖZGE IŞIKSAÇAN
Doktora
Türkçe
2020
Besin Hijyeni ve Teknolojisiİstanbul Teknik ÜniversitesiMetalurji ve Malzeme Mühendisliği Ana Bilim Dalı
PROF. DR. ONURALP YÜCEL
- Graphene based materials obtained from graphite and polyacrylonitrile based carbon fiber for energy storage and conversion systems
Enerji depolama ve dönüşüm sistemleri için grafit ve poliakrilonitril esaslı karbon fiberden grafen tabanlı malzemelerin üretilmesi
MEHMET GİRAY ERSÖZOĞLU
Doktora
İngilizce
2022
Enerjiİstanbul Teknik ÜniversitesiPolimer Bilim ve Teknolojisi Ana Bilim Dalı
PROF. DR. ABDÜLKADİR SEZAİ SARAÇ
PROF. DR. YÜCEL ŞAHİN
- V2O5 geçiş metal oksit yarı iletkenlerinin ultrasonik püskürtme tekniği ile üretilmesi ve yapısal, optiksel, elektriksel özelliklerinin incelenmesi
V2O5 transition metal oxide semiconductors produced byultrasonic spraying technique and investigation of structural,optical, electrical properties
EROL KÖSE
Yüksek Lisans
Türkçe
2018
Fizik ve Fizik MühendisliğiKütahya Dumlupınar ÜniversitesiFen Bilimleri Ana Bilim Dalı
DOÇ. DR. HURİYE SENEM AYDOĞU