Buhar sıkıştırmalı soğutma çevriminde ejektör kullanımının performansa etkisi
Effects of the ejector on vapour compression cooling system
- Tez No: 202915
- Danışmanlar: YRD. DOÇ. DR. MEHMET ÖZKAYMAK
- Tez Türü: Yüksek Lisans
- Konular: Teknik Eğitim, Technical Education
- Anahtar Kelimeler: Sogutma, Ejektör, Performans
- Yıl: 2007
- Dil: Türkçe
- Üniversite: Zonguldak Karaelmas Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Makine Eğitimi Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 47
Özet
Bu tez çalısmasında, buhar sıkıstırmalı bir sogutma çevriminde ejektör kullanılarak daha fazla verim elde edilmesi amaçlanmıs ve ejektörlü bir sogutma sistemi kurularak yapılan deneysel çalısmalarla klasik ejektör kullanılmayan bir sogutma sistemiyle aralarındaki verimler kıyaslanmıstır. Aynı sartlarda ejektörlü ve ejektörsüz olarak hazırlanan sogutma sistemleri çalıstırılarak sıcaklık ölçümleri yapılmıstır. Ejektörsüz sistemde elde elden minimum sıcaklık -10 °C iken ejektörlü sistemde sıcaklık -15°C ye kadar düsmüstür. Bu degerlere göre sistemlerin sogutma tesir katsayıları hesaplanmıstır. Ejektörsüz sistemin sogutma tesir katsayısı (COP) 2,6 çıkarken ejektör kullanılan sistemin sogutma tesir katsayısı (COP) 2,74 Çıkmıstır. Bu degerler sistemler arasında % 5 lik bir verim farkı oldugunu ve ejektörlü sistemin sistem performansına olumlu katkı yaptıgını göstermistir.
Özet (Çeviri)
n this study, getting more performance with using an ejector on vapour compression cooling system was aimed and a cooling system with ejector was designed and manufactured. At the end of the experiments and calculations the differences of two system were explained.The cooling systems which have been designed with ejector and without ejector were operated and experimental studies were done. For the each experiment, inlet and outlet temperatures of condenser, evaporator and compressor were measured by thermocouples. Minimum temparature, on the system without ejektor was -10 °C and on the system with ejector was -11°C. Acording to these values, coefficient of performance (COP) of the systems were calculated. COP of non ejektor sistem was calculated as 2,6 and COP of system with ejector was calculated as 2,74. These results expect that there is a % 5 percent performance difference between the systems and ejektor has a positive effect on the vapour compression system. Key Words :cooling, ejector, performance
Benzer Tezler
- Düşük GWP'li soğutucu akışkanların kullanımında ejektörlü soğutma sisteminin performans analizi
Performance analysis of refrigeration system with ejector in using low GWP refrigerants
ÜMİT İŞKAN
Yüksek Lisans
Türkçe
2022
EnerjiYalova ÜniversitesiEnerji Sistemleri Mühendisliği Ana Bilim Dalı
DOÇ. DR. MEHMET DİREK
- Numerical and experimental investigation of ejector use as the expander in the vapor-compression refrigeration cycle operating with a new generation refrigerant
Yeni nesil bir soğutucu akışkanla çalışan buhar sıkıştırmalı soğutma çevriminde genleştirici olarak ejektör kullanımının sayısal ve deneysel olarak incelenmesi
AYŞE UĞURCAN ATMACA
Doktora
İngilizce
2020
Makine MühendisliğiDokuz Eylül ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
PROF. DR. AYTUNÇ EREK
- Çift fazlı sabit alanlı ejektör kullanarak buhar sıkıştırmalı soğutma çevrim etkinliğinin iyileştirilmesi
Performance improvement of the vapour compression refrigeration cycle by a two-phase constant area ejector
NAGİHAN BİLİR
Yüksek Lisans
Türkçe
2009
Makine MühendisliğiSelçuk ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
YRD. DOÇ. DR. HALİL KÜRŞAD ERSOY
- Ejektörlü otobüs klimalarında ejektör boyutlarının çeşitli parametrelere göre belirlenmesi
Determination of the ejector dimensions used in bus air conditioning systems according to various parameters
UĞUR ACAR
Yüksek Lisans
Türkçe
2016
Makine MühendisliğiOsmaniye Korkut Ata ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
YRD. DOÇ. DR. ŞABAN ÜNAL
- Ultra-düşük sıcaklık uygulamaları için ejektörlü ve nanopartikül katkılı alternatif kaskad çevrimlerin termoekonomik ve çevresel performanslarının incelenmesi
Investigation of thermoeconomic and environmental performance of alternative cascade cycles incorporating ejector and nanoparticle additives for ultra-low temperature applications
SERVET GİRAY HACIPAŞAOĞLU
Doktora
Türkçe
2024
Makine MühendisliğiKocaeli ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
PROF. DR. İLHAN TEKİN ÖZTÜRK