Geri Dön

Comparison of chemical and energy consumption of acetic acid using high boiling solvent technology with respect to conventional technologies using low boiling solvents

Başlık çevirisi mevcut değil.

  1. Tez No: 28847
  2. Yazar: GÖKHAN ÖMER ALPTEKİN
  3. Danışmanlar: DOÇ. DR. AHMET ALP SAYAR
  4. Tez Türü: Yüksek Lisans
  5. Konular: Endüstri ve Endüstri Mühendisliği, Kimya Mühendisliği, Industrial and Industrial Engineering, Chemical Engineering
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 1993
  8. Dil: İngilizce
  9. Üniversite: Marmara Üniversitesi
  10. Enstitü: Fen Bilimleri Enstitüsü
  11. Ana Bilim Dalı: Endüstri Mühendisliği Ana Bilim Dalı
  12. Bilim Dalı: Belirtilmemiş.
  13. Sayfa Sayısı: 136

Özet

ÖZET Asetik asidin sulu çözeltilerinden elde edilmesi, söz konusu bileşiğin organik bir solventle ekstraksiyonu ile gerçekleştirilebilmektedir. Solventin geri kazanılması, genellikle düşük konsantrasyonda asetik asit içeren asetik asit-solvent karışımının distilasyonunu gerektirir. Distilasyon operasyonunda, tepe ürününün solvent olması durumunda enerji sarfiyatı önemli boyutlara ulaşmaktadır. Tepe ürününün asetik asit olması ile enerji gereksiniminin bağıl olarak düşük olacağı ve distilasyon operasyonunu içeren toplam prosesin, ekstraksiyon açısından teknoekonomik olarak kabul edilebilir bir ekstraktör ile yürütülebileceği ortaya konmuştur. Bu çalışmada anılan sistemde yüksek kaynayan bir solventin kullanılmasının ortaya çıkaracağı ekonomik etkinin hesaplanması hedeflenmiştir. Daha önceki deneysel çalışmalarla uygun bir solvent olduğu kanıtlanmış yüksek kaynayan solvent siklohekzil asetat ile, yaygın olarak kullanılan iki konvansiyonel solvent, etil asetat ve diizopropil eter ekonomik bazda mukayese edilmiştir. Bunların dışında vinil asetat ve metil izobütil keton da düşük kaynayan solventler olarak denenmiş ler s e de, istenilen teknik kritere (ekstraksiyon ünitesinden atılan asetik asit miktarının kütlece toplam atıkların %2' sinden az olması) ait spesifikasyona haiz olmadıklarından ekonomik olarak değerlendirilmemişlerdir. Adı geçen sistemlerin proses edileceği ekstraktör ve distilasyon kulesine ait tasarım parametrelerinin hesaplanması ASPEN PLUS adlı, kimya mühendisliği tasarım ve uygulamalarına yönelik bir bilgisayar programı vasıtası ile yürütülmüştür. iiÇalışmanın sonraki aşamalarında, adı geçen sistemlerin hesaplanan teknik spesifikasyonları kullanılarak, üretimin gerçekleşeceği tesislerin ilk yatırım harcamaları ve işletme giderleri hesaplanmıştır. Elde edilen değerler kullanılarak anılan sistemlerin dört ayrı metoda göre karlılık analizleri yapılmıştır. Sonuç olarak, siklohekzil asetatı solvent olarak kullanan sisteme ait gerek ilk yatırım gerekse işletme masraflarının teorik olarak öngörüldüğü gibi, alçak kaynayan solvent kullanan sistemlere nisbetle daha düşük olduğu ortaya çıkmıştır. iii

Özet (Çeviri)

ABSTRACT Obtaining acetic acid from its aqueous solutions is possible with the extraction of this compound by an organic solvent. Recovery of the solvent necessitates the distillation of the acetic acid-solvent mixture, containing acetic acid of low concentrations in general. In the case distillate is the solvent, energy consumption reaches significant amounts. If acetic acid could be obtained from as the top product, the energy consumption will decrease significantly. It is claimed that the total process containing distillation operation with relatively low energy consumption could be carried out by an extractor which is technoeconomically reasonable. In this master thesis, it is aimed to determine the economic impact of using a high-boiling solvent for the extraction of aqueous acetic acid solvent solutions. Cyclohexyl acetate, which has been determined as the appropriate solvent by the previous experimental research, is compared with two widely-used conventional low-boiling solvents, ethyl acetate and diisopropyl ether on an economic basis. In addition, vinyl acetate and methyl isobutyl ketone are tried in the low-boiling solvent case, but because of lack of possessing the sufficient technical constraint (having 2% or less acetic acid by weight in the waste stream of the extraction unit) they were not subjected to a further analysis. Design parameters of the extractor and the distillation tower in which the proposed systems will be processed, are computed by means of a computer program called ASPEN PLUS, which is widely-used in chemical industries' applications. xvIn the further steps of this master thesis, capital investment and operating expenses of the proposed systems are estimated by using the pre-determined technical design parameters. The systems are subjected to a profitability analysis according to four different methods. Finally, it is found that the system using cyclohexyl acetate as the solvent has significantly low capital investment as predicted theoretically, when compared with the low-boiling solvents.

Benzer Tezler

  1. Design and life cycle assessment of integrated organosolv based biorefinery: Simulated case studies utilizing sessile oak (Quercus petraea) coppices and industrial wood sawdust from Bursa/Turkey region

    Entegre organosolv bazlı biyorafineri tasarımı ve yaşam döngüsü değerlendirmesi: Bursa/Türkiye bölgesinden sapsız meşe (Quercus petraea) ve endüstriyel odun talaşı kullanarak durum çalışmaları simülasyonu

    MERVE NAZLI BORAND

    Doktora

    İngilizce

    İngilizce

    2019

    Enerjiİstanbul Teknik Üniversitesi

    Kimya Mühendisliği Ana Bilim Dalı

    PROF. DR. FİLİZ KARAOSMANOĞLU

  2. Isı yalıtımı uygulamaları için cam nanolif üretimi ve karakterizasyonu

    Fabrication and characterization of glass nanofibers for thermal insulation applications

    AHSEN ÜNAL

    Yüksek Lisans

    Türkçe

    Türkçe

    2017

    Kimya Mühendisliğiİstanbul Teknik Üniversitesi

    Kimya Mühendisliği Ana Bilim Dalı

    PROF. DR. SADRİYE OSKAY

  3. Synthesis and ınvestigation of adsorption properties of mercury-selective urea-functional polymeric resin

    Civaya seçimli üre fonksiyonlu polimerik reçinenin sentezlenmesi ve adsorpsiyon özelliklerinin incelenmesi

    SİNEM BEKTAŞ

    Yüksek Lisans

    İngilizce

    İngilizce

    2021

    Kimyaİstanbul Teknik Üniversitesi

    Kimya Ana Bilim Dalı

    PROF. DR. BAHİRE FİLİZ ŞENKAL

  4. Tekstil endüstrisinde su geri kazanım teknolojilerinin seçimine yönelik karar destek programının geliştirilmesi

    Developing decision support program for selection of water recovery technologies in textile industry

    UMUT ZENGİN

    Yüksek Lisans

    Türkçe

    Türkçe

    2021

    Kamu Yönetimiİstanbul Teknik Üniversitesi

    Çevre Eğitimi Ana Bilim Dalı

    DOÇ. DR. DERYA YÜKSEL İMER

  5. Biyokütle atıklardan aktif karbon üretimi

    Production of activated carbon from biomass wastes

    MERYEM OZMAK

    Doktora

    Türkçe

    Türkçe

    2010

    KimyaAnkara Üniversitesi

    Kimya Mühendisliği Ana Bilim Dalı

    PROF. DR. ZEKİ AKTAŞ