Quantification of quality of foamed warm mix asphalt binders and mixtures
Başlık çevirisi mevcut değil.
- Tez No: 400925
- Danışmanlar: DR. DANIŞMAN YOK
- Tez Türü: Doktora
- Konular: İnşaat Mühendisliği, Civil Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2013
- Dil: İngilizce
- Üniversite: Michigan State University
- Enstitü: Yurtdışı Enstitü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 233
Özet
Özet yok.
Özet (Çeviri)
Warm Mix Asphalt (WMA), which is the general term used for the asphalt pavements produced and placed at lower temperatures, is introduced to the pavement industry to overcome the environmental and economic challenges of Hot Mix Asphalt (HMA). WMA technologies reduce the overall mixture viscosity at lower temperatures to increase the workability of the loose mixtures, provide improved (better) compaction and facilitate aggregate coating at low temperatures. However, there are still many unknowns related to their long term performance. Foam-based WMA's are the most commonly used techniques; however there is no specification or method to evaluate the quality of foam generated by different techniques. Although producing foamed binder is relatively simple process, where hot binder is mixed with a limited amount of water (typically 2-3% by weight of the binder), the rheology of the foamed binder is not very simple. The quality of the foamed binder depends on various factors such as the binder type, grade and modification, the foaming technology used, amount of water, and temperature. Moreover, the quality of the binder plays a crucial role during the mixing, laying and compaction stages of WMA pavement production. Asphalt foams used in base stabilization applications were typically characterized using following three parameters: Expansion Ratio (ER), Half-life (HL) and Foam Index (FI). However, there is no available method to measure these parameters precisely. Therefore, an accurate and repeatable procedure is needed for the measurement of initial expansion and reduction in height of foamed asphalt in order to calculate the foam binder quality parameters. Asphalt Foam Collapse Test (AFCT), an automated test to measure the reduction in the height of the foam binder over time via image analysis, is developed during this study and validated with nondestructive 3D imaging methods (i.e., x-ray microtomography). The height reduction data obtained from AFCT is used to accurately calculate the commonly used foam quality parameters. In addition, two new parameters, Bubble Size Distribution (BSD) and Surface Area Index (SAI), are introduced as quality parameters in this study. It is found that these parameters are strong candidates for evaluating the workability and coating, as well as the performance of the pavements. A nozzle-based laboratory foamer was utilized in this study to determine the effect of water content and air pressure on the foam quality individually and in combination. Results revealed that the water content and air pressure have significant influence on ER, HL, FI, BSD, and SAI. It was observed that the low water content and low pressure produced foams with relatively small bubbles as compared to foams made with high water content and pressure. The current WMA pavement design procedures are based on limited empirical data and recommendations of the WMA technology suppliers. WMA design procedures do not consider the foam quality since its importance has not been fully understood. Therefore, the long term performance of the WMA mixtures prepared with foamed binders prepared with various injected water content and air pressures was evaluated via laboratory performance tests and compared with the foamed binder quality parameters. It was concluded that a WMA mix design should consider the foam quality, which is currently ignored
Benzer Tezler
- Gıda patojenleri için dijital PCR ile hızlı tespit yöntemlerinin geliştirilmesi
Development of rapid detection methods for food pathogens using digital PCR
YELİZ YÜCEL ÖZ
Doktora
Türkçe
2023
Biyolojiİstanbul Teknik ÜniversitesiMoleküler Biyoloji-Genetik ve Biyoteknoloji Ana Bilim Dalı
PROF. DR. AYTEN KARATAŞ
- Sağlık hizmetlerine erişim ve hastane yer seçimi: İstanbul örneği
Access to healthcare and hospital location: The case of Istanbul
MUHAMMED ZİYA PAKÖZ
Doktora
Türkçe
2014
Şehircilik ve Bölge Planlamaİstanbul Teknik ÜniversitesiŞehir ve Bölge Planlama Ana Bilim Dalı
YRD. DOÇ. DR. MEHMET ALİ YÜZER
- Biyojenik aminlerin kapiler elektroforez yöntemi ile temassız iletkenlik dedektörü kullanılarak ayrılması ve fermente gıdalarda tayini
Separation of biogenic amines by capillary electrophoresis coupled with contactless conductivity detection and determination in fermented foods
VESELİNA ADIMCILAR
Yüksek Lisans
Türkçe
2016
Kimyaİstanbul Teknik ÜniversitesiKimya Ana Bilim Dalı
PROF. DR. FATMA BEDİA BERKER
- Jeosentetikler ve karayollarında kullanımı
Başlık çevirisi yok
ÖZKAN DERNEK
Yüksek Lisans
Türkçe
1998
İnşaat Mühendisliğiİstanbul Teknik Üniversitesiİnşaat Mühendisliği Ana Bilim Dalı
PROF. DR. EMİNE AĞAR
- Turunçgil phytophthora türlerinin topraktaki populasyon yoğunluklarının saptanmasında kullanılabilecek yöntemlerin araştırılması
The Isotation techniques used for enumeration ad quantification of phytophthora specis in citrus soils
FİGEN MERT