Şeker pancarı posasından ultrason destekli pektin eldesinin Taguchi yöntemi ile optimizasyonu
Optimization of the pectin obtaining with pre-treatment ultrasound from sugar beet pulp with using Taguchi method
- Tez No: 610611
- Danışmanlar: PROF. DR. MAHMUT DOĞAN
- Tez Türü: Yüksek Lisans
- Konular: Gıda Mühendisliği, Food Engineering
- Anahtar Kelimeler: Pektin, Şeker Pancarı Posası, Optimizasyon, Kurutma, Ekstraksiyon, Pectin, Sugar Beet Pulp, Optimization, Drying, Extraction
- Yıl: 2019
- Dil: Türkçe
- Üniversite: Erciyes Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Gıda Mühendisliği Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 166
Özet
Şeker pancarı posası, yüksek pektin içeriğinden (kuru madde içinde %15-20) dolayı önemli bir pektin kaynağı olup şeker (şeker pancarı) üretiminin bir yan ürünüdür. Bu çalışmada, Taguchi L25 dizi tasarımı kullanılarak ultrasonik (45 kHz) yöntem ve klasik yöntem ile şeker pancarı artıklarından pektin üretimi gerçekleştirilerek ürün özellikleri karşılaştırılmıştır. Şeker pancarı pektininin optimum ekstraksiyon koşulları, verim ve esterifikasyon derecesi (DE) dikkate alınarak Taguchi L25 dizi tasarımı ile belirlenmiştir. Her iki üretim yönteminde de dizi tasarımı sıcaklık (60°C, 70°C, 80°C, 90°C, 95°C), pH (1 / 1,5 / 2 / 2,5 / 3), zaman (1, 2, 3, 4, 5 saat) ve katı / sıvı oranı (1:4, 1:5, 1:6, 1:7, 1:8) olmak üzere dört faktörden oluşmaktadır. Yanıt olarak, bireysel sinyal/gürültü (S / N) oranlarını hesaplamak için esterleşme derecesi (DE) ve verim analizleri gerçekleştirilmiştir. Klasik yöntem ile üretimde yüksek pektin verimi için optimum koşullar; 80 °C sıcaklık, 3 saat ve pH değeri 1.5, katı-sıvı oranı 1/8'dir. Yüksek esterleşme derecesi (DE) değeri için; 60 °C sıcaklık, 1 saat ve pH değeri 2,5, katı-sıvı oranı 1/4 olarak belirlenmiştir. Ultrasonik yöntem ile üretimde yüksek pektin verimi için optimum koşullar; 95°C sıcaklık, 4 saat ve pH değeri 1, katı-sıvı oranı 1/6'dır. Yüksek esterleşme derecesi (DE) değeri için; 90 °C sıcaklık, 4 saat ve pH değeri 2,5, katı-sıvı oranı 1/6 olarak bulunmuştur. Üretim optimizasyonu sonucu belirlenen dört farklı optimum noktada üretimi gerçekleştirilen pektin örnekleri üç farklı kurutma yöntemi ve üç farklı sıcaklık uygulanarak kurutulmuştur. Elde edilen pektin örnekleri reolojik ve renk özelliklerine göre değerlendirilerek optimum üretim ve kurutma yöntemi belirlenmiştir. Bu dört farklı optimum pektin örneğinden (UDE, UV, KDE, KV), ultrason destekli ekstraksiyon yöntemi ile üretilen ve maksimum esterleşme derecesi (DE) değerine sahip UDE örneğinin, yapılan fizikokimyasal analiz sonuçlarına göre en yüksek viskozite (113,60 cp) ve galakturonik asit değerleri (%66,52) ile en düşük kül (%4,77) ve protein değerine (%5,62) sahip olduğu belirlenmiştir. Bu pektin örneğine (UDE) uygulanan farklı kurutma işlemleri arasında püskürtmeli kurutucu ile kurutma sonucu en yüksek dinamik reolojik (G', G'' ve |η*|), steady reolojik (K, η50 ve n) ve renk (L*, a* ve b*) değerleri elde edilmiştir. Dinamik reoloji (G', G'' ve |η*|) sonuçları; kayıp modülü (G') değeri 2,83 Pa, depo modülü (G'') değeri 3,02 Pa ve kompleks viskozite (|η*|) değeri 0,66 Pa.s olarak,steady reoloji (K, η50 ve n) sonuçları; kıvam katsayısı (K) değeri 0,15 Pa.sn, viskozite (η50) değeri 0,12 Pa.s ve akış davranış indeksi (n) değeri 0,96 olarak bulunmuştur. UDE örneğine yapılan renk analiz sonuçları; L* (siyah-beyaz) değeri 91,79, a* (kırmızı-yeşil) değeri -0,39 ve b* (sarı-mavi) değerleri 1,73 olarak belirlenmiştir. Dinamik reoloji sonuçlarına göre G'' değerinin G' değerinden daha yüksek olduğu sonucuna ulaşılmıştır. Bu pektin örneğinin (UDE) viskoz özelliklerinin jel özelliklerden daha baskın oldugu anlamına gelmektedir.
Özet (Çeviri)
Sugar beet pulp is an important source of pectin due to its high pectin content (15-20% in dry matter) and is a by-product of the industrial production of sugar (sugar beet). In this study, pectin production from sugar beet waste was performed using ultrasonic (45 kHz) and classical method with Taguchi L25 array design and product characteristics were compared. The optimum extraction conditions of sugar beet pectin were determined by the Taguchi L25 array design by considering the yield and degree of esterification. In both production methods, the design of the array consisted of four factors; temperature (60°C, 70°C, 80°C, 90°C, 95°C), pH (1 / 1,5 / 2 / 2,5 / 3), time (1, 2, 3, 4, 5h) and solid / liquid ratio (1:4, 1:5, 1:6, 1:7, 1: 8). The optimum conditions for maximum yield of pectin in classical method; 80°C temperature, 3 hours and pH value of 1.5, solid-liquid ratio 1/8; for high degree of esterification (DE) 60°C, 1 hour and pH value of 2.5, solid-liquid ratio 1/4 was determined. The optimum points for maximum yield of pectin, by using ultrasonic method; 95°C temperature, 4 hours and pH value of 1, solid-liquid ratio 1/6, for high DE 90°C temperature, 4 hours and a pH value of 2.5 and a solid-liquid ratio of 1/6 was found. The pectin samples were produced at four different optimum points. The determined production optimization were applied by three different drying methods and three different temperatures. The pectin samples were evaluated according to their rheological and color characteristics. The optimum production and drying methods were determined. According to the results of physicochemical analysis, the highest viscosity (113.60 cp) and galacturonic acid (%66.52) with the lowest ash (%4.77) and protein values (%5.62) were obtained from one of these four different pectin (UDE, UV, KDE, KV) sample. UDE which produced by using the ultrasound assisted extraction method. This sample also had maximum esterification degree (DE). From these optimum pectin samples (UDE, UV, KDE, KV), maximum DE was obtained by ultrasound assisted extraction method. UDE, sample which was dried by spray dryer has the highest dynamic rheological (G', G'' ve |η*|), steady rheological (K, η50 ve n) and color (L*, a* ve b*) values, among the different drying processes. Dynamic rheology (G ', G' 'and | η * |) results; the loss modulus (G ') value was 2.83 Pa, the storage module (G' ') value was 3.02 Pa and the complex viscosity (| η * |) value was 0.66 Pa.s. The consistency coefficient (K), viscosity (η50), flow behavior index (n) values of the samples were 0.15 Pa.sn, 0.12 Pa.s and 0.96, respectively. The results of the UDE sample's color were found as L * (black and white) value was 91.79, a * (red-green) value was -0.39 and b * (yellow-blue) value was 1.73. According to the results of dynamic rheology, it was concluded that G'' value was higher than G' value. This means that the viscous properties of the pectin sample (UDE) were more dominant than the gel properties.
Benzer Tezler
- Extraction, characterization and usage of pectin from sugar beet pulp waste
Şeker pancarı posa atığından pektinin kstraksiyonu,karakterizasyonu ve kullanımı
ELİF KARTAL
Yüksek Lisans
İngilizce
2024
Gıda Mühendisliğiİstanbul Teknik ÜniversitesiGıda Mühendisliği Ana Bilim Dalı
PROF. DR. MERAL KILIÇ AKYILMAZ
- Ultrason ön uygulamalı ve mikrodalga kurutma yöntemi ile şeker pancarı posasından diyet gıda lifi eldesi
Dietary fiber production from sugar beet pulp with ultrasound pretreatment and microwave drying
AYLİN ÖZGÜR GÖKSU
Doktora
Türkçe
2019
Gıda MühendisliğiErciyes ÜniversitesiGıda Mühendisliği Ana Bilim Dalı
PROF. DR. MAHMUT DOĞAN
- Şeker pancarı posasından aktif karbon üretimi ve gümüş bazlı biyokompozit polilaktik asit filmlerde uygulanması
Production of activated carbon from sugar beet pulp and its application in silver based biocomposite polylactic acid films
SİNEM GÜNEŞ
Doktora
Türkçe
2024
Gıda MühendisliğiSakarya ÜniversitesiGıda Mühendisliği Ana Bilim Dalı
PROF. DR. DİLEK ANGIN YILMAZ
PROF. DR. ZEHRA AYHAN
- Ultrasound ön uygulamasının şeker pancarı posasından elde edilen selüloz ve karboksimetil selüloz (CMC)'nin verim ve kalitesi üzerine etkisi
Effect of ultrasound pre-treatment on the yield and quality of cellulose and CMC obtained from sugar beet pulp
FATMA DOĞAN
Yüksek Lisans
Türkçe
2019
Gıda MühendisliğiErciyes ÜniversitesiGıda Mühendisliği Ana Bilim Dalı
PROF. DR. MAHMUT DOĞAN
- Polianilin ve şeker pancarı posasından elde edilen kompozitlerin atık sulardan nikel ve bakırın uzaklaştırılmasında adsorbent olarak kullanılması
Use of composites obtained from polyaniline and sugar beet pulp as an adsorbent to remove nickel and copper from wastewater
KEVSER YİĞİT
Yüksek Lisans
Türkçe
2015
KimyaMehmet Akif Ersoy ÜniversitesiKimya Ana Bilim Dalı
DOÇ. DR. SONGÜL ŞEN GÜRSOY