Geri Dön

İtakonik asidin organofosforik özütleyiciler kullanılarak sulu çözeltilerden tepkimeli özütlenmesi

Recovery of itaconic acid from aqueous solutions usingorganophosphoric extractants by reactive extraction

  1. Tez No: 687089
  2. Yazar: MERYEM COPLAN
  3. Danışmanlar: DOÇ. DR. MUSTAFA ESEN MARTI
  4. Tez Türü: Yüksek Lisans
  5. Konular: Kimya Mühendisliği, Chemical Engineering
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 2021
  8. Dil: Türkçe
  9. Üniversite: Konya Teknik Üniversitesi
  10. Enstitü: Lisansüstü Eğitim Enstitüsü
  11. Ana Bilim Dalı: Kimya Mühendisliği Ana Bilim Dalı
  12. Bilim Dalı: Belirtilmemiş.
  13. Sayfa Sayısı: 92

Özet

İtakonik asit, biyobozunur polimerik malzemelerin sentezinde kullanılabilen çok yönlü bir dikarboksilik asittir. Buna ek olarak ilaç, boya, reçine, biyo-yakıt ve medikal ürünlerin sentezinde yaygın olarak kullanılmaktadır. Artan talep ve mevcut yöntemlerin ekonomik ve çevresel yetersizlikleri yeni üretim ve ayırma yöntemlerinin geliştirilmesini gerektirmiştir. Bu tez çalışmasında itakonik asidin sulu çözeltilerden tepkimeli özütleme yöntemi ile ayrımı araştırılmıştır. Çalışmada bir organofosforik özütleyici olan trioktilfosfin oksit (TOPO) kullanılmıştır. İtakonik asit derişimi 0,05-0,5 mol/L arasında iken TOPO derişimi 0,2 ile 0,8 mol/L aralığında olmuştur. Organik fazda çözücü olarak toluen, metil izobütil keton (MIBK), oktanol ve dekanol test edilmiştir. Fiziksel özütleme deneylerinde toluen ile itakonik asidin organik faza aktarılamadığı fakat MIBK, oktanol ve dekanol ile aktarıldığı gözlenmiştir. Sabit özütleyici derişiminde artan başlangıç pH değeri ile birlikte geri kazanım verimi çözeltinin doğal pH değerine kadar yükselmiş sonrasında düşmüştür. En yüksek geri kazanım verimine çözeltinin doğal pH değerinde (pH= 2,14) erişilmiştir. Sistem 60 dakikada dengeye ulaşmıştır. Üç farklı sıcaklık noktasında elde edilen bulgular sıcaklık artışının ayırma verimine olumsuz etkisini göstermiştir. En yüksek ayırma verimleri toluen ve MIBK ile sırasıyla %96,08 (KD= 24,50) ve %94,12 (KD= 16,00) olmuştur. Bu iki çözücü için TOPO derişiminin artmasıyla geri kazanım verimi artarken asit derişiminin artması ile verim düşmüştür. Yükleme değerleri birden düşük olmuştur. Sonuçlar TOPO özütleyicisinin itakonik asit geri kazanımı için uygun bir çözücü ile birlikte kullanılabileceğini göstermiştir.

Özet (Çeviri)

Itaconic acid is a versatile dicarboxylic acid that can be used in the synthesis of biodegradable polymeric materials. In addition, it is widely used in the synthesis of pharmaceuticals, dyes, resins, biofuels and medical products. The increasing demand and the economic and environmental inadequacies of existing methods necessitated the development of new production and separation methods. In this thesis study, the separation of itaconic acid from aqueous solutions by reactive extraction method was investigated. Trioctylphosphine oxide (TOPO), an organophosphoric extractant, was used in the study. While the concentration of itaconic acid was between 0,05-0,5 mol/L, the concentration of TOPO was between 0,2 and 0,8 mol/L. Toluene, methyl isobutyl ketone (MIBK), octanol and decanol were tested as solvents in the organic phase. In physical extraction experiments, it was observed that itaconic acid could not be transferred to the organic phase with toluene, but was transferred with MIBK, octanol and decanol. At constant extractant concentration, the recovery efficiency increased up to the natural pH value of the solution and then decreased. The highest recovery efficiency was reached at the natural pH value of the solution (pH= 2,14). The system reached equilibrium in 60 minutes. The results obtained at three different temperature points showed the negative effect of temperature increase on separation efficiency. The highest separation efficiencies were 96,08% (KD= 24,50) and 94,12% (KD= 16,00) with toluene and MIBK, respectively. For these two solvents, the recovery efficiency increased with the increase in TOPO concentration while decreased with the increase in acid concentration. Loading factors were less than unity. The results showed that TOPO extractant can be used with a suitable solvent for itaconic acid recovery

Benzer Tezler

  1. Organo fosfonik asit içeren vinil polimerler sentezi

    The synthesis of vinly polymeric containing organophosphonic acid

    NESRİN KÖKEN ÖZ

    Doktora

    Türkçe

    Türkçe

    1997

    Kimyaİstanbul Teknik Üniversitesi

    Kimya Ana Bilim Dalı

    PROF. DR. AHMET AKAR

  2. İtakonik asidin anyonik reçineler kullanılarak sulu fazlardan ayrımı

    Separation of itaconic acid from aqueous phases using anionic resins

    CİHAT ERDEM CAN

    Yüksek Lisans

    Türkçe

    Türkçe

    2018

    Kimya MühendisliğiSelçuk Üniversitesi

    Kimya Mühendisliği Ana Bilim Dalı

    DOÇ. DR. MUSTAFA ESEN MARTI

  3. Poli(itakonik asit-co-glisidil metakrilat)kopolimerlerinin sentezi ve karakterizasyonu

    Synthesis and characterization of poly(itaconic acid-co-glycidyl methacrylate)copolymers

    PINAR AYTEKİN BOZKURT

    Yüksek Lisans

    Türkçe

    Türkçe

    2018

    Polimer Bilim ve TeknolojisiGaziantep Üniversitesi

    Kimya Ana Bilim Dalı

    DOÇ. DR. HİDAYET MAZI

  4. Grafting copolymerization of itaconic acid and its derivatives onto polyolefines

    İtakonik asit ve türevlerinin poliolefinler üzerine aşı koplolimerizasyonu

    GÜLNUR BAŞER

    Yüksek Lisans

    İngilizce

    İngilizce

    2005

    Polimer Bilim ve Teknolojisiİstanbul Teknik Üniversitesi

    Polimer Bilim ve Teknolojisi Ana Bilim Dalı

    PROF.DR. CANDAN ERBİL

    PROF.DR. NURSELİ UYANIK

  5. Nanoparticles and nanofibers of Poly(Acrylonitrile-co-Itaconic acid)/Polythiophene composites

    Poli(Akrilonitril-ko-Itakonik asit)/Politiyofen kompozit yapıların nanopartikül ve nanolifleri

    HAVVA BAŞKAN

    Yüksek Lisans

    İngilizce

    İngilizce

    2015

    Polimer Bilim ve Teknolojisiİstanbul Teknik Üniversitesi

    Tekstil Mühendisliği Bölümü

    PROF. DR. HALE KARAKAŞ

    PROF. DR. ABDÜLKADİR SEZAİ SARAÇ