İmplant ve doğal diş destekli overdenture protezlerdeki stres dağılımının sonlu elemanlar stres analizi yöntemi ile değerlendirilmesi
The evaluation of the stress distribution on implant-natural tooth supported overdenture prostheses by finite elemet stress analysis
- Tez No: 830498
- Danışmanlar: PROF. DR. FATİH MEHMET KORKMAZ
- Tez Türü: Doktora
- Konular: Diş Hekimliği, Dentistry
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2023
- Dil: Türkçe
- Üniversite: Karadeniz Teknik Üniversitesi
- Enstitü: Sağlık Bilimleri Enstitüsü
- Ana Bilim Dalı: Protetik Diş Tedavisi Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 126
Özet
İmplantların alveolar kemik ile bağlantısının rijit olması ve doğal dişlerin periodontal membran nedeniyle belirli bir esnekliğe sahip olması implant-doğal diş destekli overdenture protezlerde biyomekanik açıdan sorunlar oluşturabilir. Bu çalışmanın amacı; farklı sayıda implantların kullanıldığı doğal diş ve implant destekli overdenture protezlerde protez üzerine gelen kuvvetlerin kortikal ve spongioz kemikte oluşturduğu streslerin sonlu elemanlar stres analizi yöntemiyle incelenmesidir. Bu çalışmada bilgisayar ortamında oluşturulmuş 3 boyutlu alt çene modeli üzerine doğal diş ve implantlar 9 farklı kombinasyonda yerleştirilerek 9 farklı overdenture protez tasarlanmıştır. Overdenture protez üzerine vertikal yönde 150 N'luk yük posterior dişlere dağıtılarak 3 farklı şekilde uygulandı. Birinci yükleme alt çenenin sağ tarafına, ikinci yükleme alt çenenin sol tarafına, üçüncü yükleme ise alt çenenin her iki tarafına birden olacak şekilde uygulanmıştır. Bu yüklemeler sonucunda doğal diş ve implantların etrafındaki kortikal ve spongioz kemikte oluşturduğu Von Mises stresleri incelenmiştir. Çalışma sonucunda tüm yüklemlerde en yüksek streslerin doğal dişin veya implantın etrafındaki kortikal kemikte görüldüğü tespit edilmiştir. Bir adet doğal diş ve bir adet dental implantın bar ile bağlandığı tasarım (Model 3) kortikal kemikte tüm yüklemelerde diğer tüm modellerden daha yüksek stres değerleri oluşturmuştur (Model 1 hariç). Kortikal kemikte bar tutuculu ve topuz başlı tutuculu modellerden aynı destek sayısına sahip olanlar birbiriyle kıyaslandığında topuz başlı tutuculu modellerdeki stres miktarları bar tutuculu modellerdeki stres miktarlarından daha düşük tespit edilmiştir. Bar tutuculu tasarımlarda implant sayısının artması kortikal kemikte oluşan stresleri azaltırken topuz başlı tutuculu tasarımlarda bu durum tüm yüklemelerde aynı faydayı sağlamamıştır. Elde edilen sonuçlara göre; mandibulada tek diş varlığında çenenin karşı tarafına en az bir adet dental implant yerleştirmek biyomekanik açıdan ciddi yarar sağlarken, kortikal kemikte bar tutuculu tasarımlara göre daha az strese neden olan topuz başlı tutuculu tasarımlar biyomekanik açıdan daha avantajlı olabilir.
Özet (Çeviri)
The rigidity of the connection of the implants with the alveolar bone and the flexibility of the natural teeth due to the periodontal membrane may cause biomechanical problems in implant-natural tooth supported overdenture prostheses. The aim of this study was to determine the stresses caused by the forces acting on the prosthesis on the cortical and cancellous bone in natural teeth and implant supported overdenture prostheses, in which different numbers of implants were used by finite element stress analysis method. In this study, 9 different overdenture prostheses were designed by placing natural teeth and implants in 9 different combinations on the 3D mandibular model created in the computer environment. A load of 150 N was carried out on the overdenture prosthesis in 3 different ways by distributing it to the posterior teeth in the vertical direction. The first loading was applied to the right side of the lower jaw, the second loading was performed to the left side of the lower jaw and the third loading was enforced to both sides of the lower jaw. As a result of these loadings, Von Mises stresses were investigated on cortical and cancellous bone around natural teeth and implants. The highest stresses which observed in the cortical bone around the natural tooth or implant in all loads were determined in consequence of the study. The design with one natural tooth and one dental implant with a bar (Model 3) produced higher stress values on the cortical bone at all loadings than all other models (except Model 1). The stress rates in the models with ball atachment holders were detected to be lower than the stress amounts in the models with bar holders when they copmpared to each other with the models with bar holder and ball atachment holder in the cortical bone with the same support number. While the increase in the number of implants in bar-retained designs reduces the stresses on the cortical bone, this procedure did not provide the same benefit in all loadings in ball-head-retained designs. According to the results obtained from this study; in the meanwhile placing at least one dental implant on the opposite side of the jaw in the presence of a single tooth in the mandible ensures significant biomechanical benefits, designs with ball-head attachments that cause less stress on the cortical bone than designs with bar retainers may be more biomechanically advantageous.
Benzer Tezler
- Geleneksel ve implant destekli alt tam protezlerde alt çeneye gelen gerilmelerin deneysel ve sayısal yöntemlerle analizi
Analysis of stresses acting on the lower jaw beneath conventional and implant supported lower full dentures with experimental and numerical methods
AHMET ALTUĞ ÇİLİNGİR
Doktora
Türkçe
2005
Diş Hekimliğiİstanbul ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
PROF. DR. MUZAFFER ATEŞ
- Dişli ve dişsiz bireylerin ısırma kuvvetinin değerlendirilmesi
Evaluation of bite force for dentate and edentulous individuals
GİZEM ÖZCAN
Doktora
Türkçe
2017
Diş HekimliğiAnkara ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
PROF. DR. SADULLAH ÜÇTAŞLI
- İmplant destekli tam protezlerde kullanılan farklı tutucuların retansiyonlarının değerlendirilmesi
Retention of different attachments on implant supported overdenture
SELİN ÜMMÜ ÖZSOY UÇAR
Diş Hekimliği Uzmanlık
Türkçe
2019
Diş HekimliğiCumhuriyet ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
DOÇ. DR. DERYA ÖZDEMİR DOĞAN
- Serbest sonlu hareketli bölümlü protez ve tam protez hastalarının implant tedavisini reddetme nedenleri ile dental anksiyetelerinin/korkularının değerlendirilmesi
Association of dental anxiety and fear with reasons for refusal of implant treatment in cases with free-ended partial edentulism and total edentulism
MERT ARAL
Doktora
Türkçe
2024
Diş HekimliğiAnkara ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
PROF. DR. YASEMİN KESKİN
- Rijit ve semirijit bağlantılı implant-diş ve implant-implant destekli sabit parsiyel protezlerde kemik içerisinde oluşan stres dağılımının incelenmesi
The evaluation of stress distribution in supporting bone with rigid and semirigid connected implant-tooth and implant-implant supported fixed partial dentures
DİLEK ENHOŞ
Doktora
Türkçe
2007
Diş HekimliğiSelçuk ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
PROF.DR. ÖZGÜR İNAN