Üst çenede iki implant destek üzerine uygulanan mezial uzantılı restorasyonlarda, okluzal kuvvetlerin implant çevre dokularında neden olduğu stres dağılımının üç boyutlu sonlu elemanlar stres analizi yöntemi ile incelenmesi
Evaluation of stress distribution of occlussal forces in periimplant tissues in maxillary two implant retained mesial cantilevered restorations with 3-D finite element analysis
- Tez No: 426952
- Danışmanlar: PROF. DR. ÖZGÜL KARACAER
- Tez Türü: Doktora
- Konular: Diş Hekimliği, Dentistry
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2015
- Dil: Türkçe
- Üniversite: Gazi Üniversitesi
- Enstitü: Sağlık Bilimleri Enstitüsü
- Ana Bilim Dalı: Protetik Diş Tedavisi Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 121
Özet
Geniş alanlı kemik greftleme ihtiyacı, estetik kısıtlamalar, zayıf kemik kalitesi, implant kaybı ve ekonomik kısıtlamalar gibi durumlar hekimleri implant destekli kantilever protezlere yönlendirmektedir. Ancak kantilever varlığında implant ve implant çevre dokularına iletilen kuvvetler artmaktadır. Bu çalışmada amaç, farklı çaplardaki implant destek kombinasyonlarının kullanıldığı kantilever köprüleri birbirleri arasında değerlendirmektir. Çalışmada, D3 kemik özelliğinde; 1. molar, 1. premolar ve 2. premoları olmayan maksillanın 3 boyutlu matematiksel modeli kullanılmıştır. Aynı boy fakat farklı çapta iki implant 1. molar ve 2. premolar bölgelerine 4 farklı modelde yerleştirilmiş ve üzerine mezial uzantılı 3 üyeli kantilever protez modellenmiştir. Restorasyonların palatinal tüberkülünden kuvvet uygulanarak Algor Fempro analiz programı ile 3 boyutlu sonlu elemanlar analizi yapılmıştır. Yapılan analizler sonucu birinci konnektörde, implantların boyun bölgesinde ve birincil implantın çevresindeki kortikal kemikte stres yoğunlaşmaları görülmüştür. Konnektörlerde oluşan stresin implant çaplarındaki değişimden anlamlı ölçüde etkilenmediği görülürken implantlar ve implant çevre dokularındaki stresin çap artışıyla azaldığı görülmüştür. En yüksek stres yoğunluğu iki implantın daha dar olduğu modelde görülürken, en düşük yoğunluk iki implantın daha geniş çaplı kullanıldığı durumda görülmüştür. İki implant farklı çaplarda kullanıldığında ise, kantilevere yakın implantın daha geniş çaplı olmasının stres dağılımını azalttığı görülmüştür.
Özet (Çeviri)
Extensive bone grafting need, esthetic restrictions, poor bone quality, implant loss and economical restrictions makes the doctors choose implant supported cantilever prostheses. But presence of a cantilever increases the forces effecting the implant and the peri-implant tissues. The objective of this study is, to compare the cantilever prostheses supported with different diametered implants. In tis study, 3 dimensional mathematical model of a maxilla at D3 bone quality without a first molar, first premolar and second premolar is used. Two implants at the same length but different diameters are located at the fisrt molar and second premolar region in 4 models and above them 3 units mesial cantilevered prostheses is modelled. From the palatinal tubercules of the restorations force is applied and using the Algor Fempro analysis programme 3 dimensional finite elements analysis is done. It is seen that the stress distribution at the first connector, the neck region of implants and the cortical bone around the first implant was higher. Also it is seen that the stress at the connectors is not effected from the change of supporting implant diameters but the stress at the implant and peri-implant tissues is decreased by the increase of diameter. The highest stres distribution is found when both the implants are thick diametered, the lowest distribution is found around the implants with wide diameters. It is seen that when the two supporting implants are at different diameters, the wider implant near the cantilever decreases the stres distribution.
Benzer Tezler
- Geleneksel ve implant destekli alt tam protezlerde alt çeneye gelen gerilmelerin deneysel ve sayısal yöntemlerle analizi
Analysis of stresses acting on the lower jaw beneath conventional and implant supported lower full dentures with experimental and numerical methods
AHMET ALTUĞ ÇİLİNGİR
Doktora
Türkçe
2005
Diş Hekimliğiİstanbul ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
PROF. DR. MUZAFFER ATEŞ
- Palatinal implant destekli üst molar distalizasyonunun sefalometrik ve model analizleriyle incelenmesi
Evaluation of upper first molar distalization supported by palatal implants with cepholometric radiographs and model analysis
SERDAR SEZEN
- Atmosferik soğuk plazma ve mezenkimal kök hücre ile modifiye edilen titanyum yüzeylerde osteojenik hücreaktivitelerinin değerlendirilmesi
The evaluation of the osteogenic cell activities on titanium surface modified with the atmospheric cold plasma and mesenchymal stem cells
MEHMET BURAK KAPILI
Diş Hekimliği Uzmanlık
Türkçe
2017
Diş Hekimliğiİzmir Katip Çelebi ÜniversitesiAğız Diş ve Çene Cerrahisi Ana Bilim Dalı
YRD. DOÇ. DR. MURAT ULU
- Dişli ve dişsiz bireylerin ısırma kuvvetinin değerlendirilmesi
Evaluation of bite force for dentate and edentulous individuals
GİZEM ÖZCAN
Doktora
Türkçe
2017
Diş HekimliğiAnkara ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
PROF. DR. SADULLAH ÜÇTAŞLI
- Self-tapping ve self-drilling ortodontik mikro implantların ortodontik tedavi sürecinde stabilitelerinin karşılaştırmalı değerlendirilmesi
Comparative evaluation of the stability of self-tapping and self-drilling orthodontic micro implants during orthodontic treatment
SİNA YILDIRIM
Doktora
Türkçe
2014
Diş HekimliğiKaradeniz Teknik ÜniversitesiOrtodonti Ana Bilim Dalı
YRD. DOÇ. DR. MEHMET BİROL ÖZEL