In vitro simulation of implant surface decontamination with different instrumentation tools in a surgical approach
Implant yüzeylerinin temizliğinin cerrahi yaklaşim simüle edilerek farklı aletler kullanılarak ın vitro olarak değerlendirilmesi
- Tez No: 884937
- Danışmanlar: DOÇ. DR. EBRU ÖZKAN KARACA
- Tez Türü: Yüksek Lisans
- Konular: Diş Hekimliği, Dentistry
- Anahtar Kelimeler: peri-implantitis, cerrahi periodontal tedavi, temizlik etkinliği, Periimplantitis, Periimplantitis
- Yıl: 2023
- Dil: İngilizce
- Üniversite: Yeditepe Üniversitesi
- Enstitü: Sağlık Bilimleri Enstitüsü
- Ana Bilim Dalı: Periodontoloji Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: Belirtilmemiş.
Özet
Bu in vitro çalışmanın amacı, üç farklı periodontal tedavi aletinin dental implant yüzeylerindeki temizleme etkinliklerini değerlendirmektir. Çalışmada geniş açılı (180°) stardardize edilmiş otuz adet epoksi rezin modele gömülü yüzeyleri boyanmış implantlar kullanıldı. İmplantlar üç farklı çalışma grubuna göre ayrıldı. Standardize edilmiş peri-implant modellerde dişeti dokusu içermeksizin, implant yüzeylerinin cerrahi olarak tedavisini amaçlayan açık cerrahi tekniği simule edilmiştir. İmplant yüzeylerinde ultrasonik doğrusal salınım yapan bir cihazın implant yüzeylerinde uygulanan farklı üç ucu, paslanmaz çelik uç (SST), karbon fiber uç (CFT), ve poli eter keton (PEEK) uç kullanılmıştır (her gruptaki örnek sayısı 10 ). Uygulamaları tamamlanan implant yüzeylerinin fotoğraflarının bilgisayar programı ile değerlendirilmesi çalışma gruplarını bilmeyen ve kalibre bir araştırmacı tarafından yapıldı. Çalisma sonuçlarinda toplam temizlenen alan değerlendirilmesine bakıldığında, gruplar arasında istatistiksel olarak anlamlı bir fark olduğunu göruldu (p:0,001; p<0,05). Ortalama temizlenen alan yüzdesinin değerlendirmesine bakıldığında SST grubunun alan yüzdesinin CFT ve PT gruplarına göre istatistiksel olarak anlamlılığı yüksek bulundu ((p<0.05). Her ne kadar SST grubundaki temizlenen alan yüzdesi CFT ve PT grubuna göre yüksek olsa da, total alanın hepsinin temizlenemediği görüldü. Sonuç olarak, çalışmanın verilerinin analizi sonucunda, SST grubu yüzey temizliğinin değerlendirildiği gruplar arasında en iyi olarak grup olarak öne çıkmasına rağmen, bu grup tarafından tüm alanın temizlenemediği görülmüştür.
Özet (Çeviri)
Aal Jabro, N. (2023) In Vitro Simulation of Implant Surface Decontamination with Different Instrumentation Tools in a Surgical Approach. Yeditepe University, Faculty of Dentistry, Department of Periodontology, MSC thesis, İstanbul. The objective of this research is to conduct a laboratory assessment of three periodontal treatment tools and evaluate their efficiency on dental implant surface decontamination. To achieve this goal, thirty ink-stained implants were inserted into standardized epoxy resin models simulating horizontal bone defects at an angle of 180°. Implants were categorized into three distinct study groups accordingly. The standardized peri-implantitis models utilized in this study do not include any visible gingival tissue, as they are simulating an open flap debridement approach for treating implant surfaces surgically. Vector Paro Pro® device (VPP) with the use of the ultra-sonic linear oscillating handpiece (LOH) along with use of three special tips designated for implant surface debridement consisting of a stainless-steel tip (SST), a carbon-fiber tip (CFT) and a polyether ether ketone (PEEK) tip; the implants were divided on these tips (with each group at n=10). An examiner who was both blinded and calibrated assessed the standardized images of treated implant surfaces using image-processing software. The results showed that there was a statistically significant difference between the groups in terms of the areas cleaned (p:0.001; p <0.05). As a result of the mean cleared area, SST group was found to be significantly higher than the CFT and PT groups (p<0.05). In return, the final percentage of cleared area of the SST group was determined to be significantly higher compared to the CFT and PT groups (p <0.05) suggesting that within the parameters of this in-vitro study the SST group had achieved the best results in comparison to the other two groups, although even in this superior group total cleanliness was not achieved. In conclusion, the SST group showed significant results being the most efficient decontamination method compared to the other two groups after analysis; although it is crucial to acknowledge that full decontamination was not fully achieved by that group.
Benzer Tezler
- Tek distal uzantılı zirkonyum restorasyonları destekleyen ti-altyapılı zirkonyum dayanakların yorulma dayanımlarının ve kırılma direnclerinin in vitro olarak incelenmesi
The in vitro investigation of fatigue strength and fracture resistance of ti-base zirconia abutment supported zirconia restorations with distala single extension
NIGAR BAGHIROVA
Doktora
Türkçe
2019
Diş HekimliğiHacettepe ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
PROF. DR. HATİCE CANAN HEKİMOĞLU
- The effects of different mechanical ınstrumentations on ımplant surfaces
Farklı mekanik aletlerin implant yüzeylerindeki etkileri
MÜGE MÜEZZİNOĞLU
Doktora
İngilizce
2023
Diş HekimliğiYeditepe ÜniversitesiPeriodontoloji Ana Bilim Dalı
PROF. DR. BAHAR KURU
DOÇ. DR. OGÜL LEMAN TUNAR
- Yerli olarak tasarlanmış ve üretilmiş“derin iç altıgen şekilli implant gövde ve destek bağlantılarının”çiğneme kuvvetleri altındaki davranışlarının değerlendirilmesi
Evaluation of the behavior of“deep internal hexagonal shaped implant body and abutment connections”designed and produced domestically under masticatory forces
YEZDAN DİLAN ERKCAN
Doktora
Türkçe
2021
Diş HekimliğiAnkara ÜniversitesiProtetik Diş Tedavisi Ana Bilim Dalı
PROF. DR. MEHMET ALİ KILIÇARSLAN
PROF. DR. BURAK BİLECENOĞLU
- Retinal and neural stimulation with quantum dots based photovoltaic interfaces
Kuantum nokta temelli fotovoltaik arayüzlerle retinal ve nöral stimülasyon
ERDOST YILDIZ
Doktora
İngilizce
2021
BiyomühendislikKoç ÜniversitesiNörobilim Ana Bilim Dalı
PROF. DR. AFSUN ŞAHİN
PROF. DR. YASEMİN ÖZDEMİR
- Cyclic and corrosion behavior of nickel titanium shape memory alloys modified with various biocompatible coatings
Başlık çevirisi yok
GÖRKEM MUTTALİP ŞİMŞEK
Doktora
İngilizce
2023
Makine MühendisliğiÖzyeğin ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
PROF. DR. GÜNEY GÜVEN YAPICI