Geri Dön

Farklı silt karışım oranlarının santirifüj pompa karakteristikleri ve çark malzemeleri üzerine etkisi

The effects of impeller materials and characteristics of centrifugal pump of different silt mixing rate

  1. Tez No: 167606
  2. Yazar: MURAT KARACA
  3. Danışmanlar: DOÇ.DR. SEDAT ÇALIŞIR
  4. Tez Türü: Yüksek Lisans
  5. Konular: Ziraat, Agriculture
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 2005
  8. Dil: Türkçe
  9. Üniversite: Selçuk Üniversitesi
  10. Enstitü: Fen Bilimleri Enstitüsü
  11. Ana Bilim Dalı: Tarım Makineleri Ana Bilim Dalı
  12. Bilim Dalı: Belirtilmemiş.
  13. Sayfa Sayısı: 41

Özet

ABSTRACT MS Thesis THE EFFECTS ON IMPELLER MATERIALS AND CHARAKTERTTICS OF CENTRIFUGAL PUMP OF DIFFERENT ŞİLT MEONG RATE Murat KARACA Selçuk Universty Graduate School of Natural and Applied Sciences Department of Agricultural Machinery Supervisor: Assoc. Prof. Di. Sedat ÇALIŞIR 2005,Page:41 Jnry:Assoc. Prof Dr. Sedat ÇALIŞIR Assoc. Prof. Dr. Cevat AYDIN Asst. Assoc. Prof. Dr. Haydar HACISEFEROĞULLARI in this research, the effeet on impeller material and characteristics of centri&gal pump for 3" using irrigation of different süt mixing rate were determined. The experiment was designed to use three levels of şilt mixed rate, ranging from 1% to 5%, and three different materials (cast iron, sfero and hronze) of impeller pump. The results show that, system efficiency, pressure and flow rate of pump decreased while power consumption and wear of impeller were increasing as increasing of şilt mixing rate. At the some amount of şilt mbcing, the least and most performance were obtained the cast iron and hronze respectively. KEY WODRS: Centrifugal pump, şilt mbdng rate, wear. iv

Özet (Çeviri)

ABSTRACT MS Thesis THE EFFECTS ON IMPELLER MATERIALS AND CHARAKTERTTICS OF CENTRIFUGAL PUMP OF DIFFERENT ŞİLT MEONG RATE Murat KARACA Selçuk Universty Graduate School of Natural and Applied Sciences Department of Agricultural Machinery Supervisor: Assoc. Prof. Di. Sedat ÇALIŞIR 2005,Page:41 Jnry:Assoc. Prof Dr. Sedat ÇALIŞIR Assoc. Prof. Dr. Cevat AYDIN Asst. Assoc. Prof. Dr. Haydar HACISEFERO?ULLARI in this research, the effeet on impeller material and characteristics of centri&gal pump for 3" using irrigation of different süt mixing rate were determined. The experiment was designed to use three levels of şilt mixed rate, ranging from 1% to 5%, and three different materials (cast iron, sfero and hronze) of impeller pump. The results show that, system efficiency, pressure and flow rate of pump decreased while power consumption and wear of impeller were increasing as increasing of şilt mixing rate. At the some amount of şilt mbcing, the least and most performance were obtained the cast iron and hronze respectively. KEY WODRS: Centrifugal pump, şilt mbdng rate, wear. iv

Benzer Tezler

  1. Kimyasal enjeksiyon yapılmış siltli-ince kum karışımlarının mühendislik özelliklerinin araştırılması

    Investigation of engineering properties of chemical grouted silty-fine sand mixtures

    EMRE DEVECİ

    Yüksek Lisans

    Türkçe

    Türkçe

    2020

    İnşaat MühendisliğiBursa Teknik Üniversitesi

    İnşaat Mühendisliği Ana Bilim Dalı

    DOÇ. DR. EYÜBHAN AVCI

  2. Rüzgarlı yağış koşullarında eğim yönünün yüzey akış sediment taşınımı üzerine etkisi

    The effect of slope aspect on sediment transport by shallow overland flow under wind-driven rain

    HİLAL SAMRAY

    Yüksek Lisans

    Türkçe

    Türkçe

    2006

    ZiraatAnkara Üniversitesi

    Toprak Ana Bilim Dalı

    DOÇ. DR. GÜNAY ERPUL

  3. Permeasyon enjeksiyonu uygulamalarında enjekte edilebilirlik sınır basınç değerlerinin belirlenmesi

    Determination of limits grouting pressure in permeation injections

    GÖZDE ALGÜN

    Yüksek Lisans

    Türkçe

    Türkçe

    2023

    İnşaat MühendisliğiBursa Teknik Üniversitesi

    İnşaat Mühendisliği Ana Bilim Dalı

    DOÇ. DR. EYÜBHAN AVCI

  4. Siltli zeminlerin konsolidasyon karakteristikleri

    Consolidation characteristics of silty soils

    YADİGAR ALTUNDAĞ

    Yüksek Lisans

    Türkçe

    Türkçe

    2016

    Mühendislik BilimleriSakarya Üniversitesi

    İnşaat Mühendisliği Ana Bilim Dalı

    DOÇ. DR. AŞKIN ÖZOCAK

  5. Geçirimli beton tasarımı ve zemin kaplama bloklarında kullanım olanaklarının araştırılması

    Pervious concrete design and investigation of usage in floor paving blocks

    ÖZGÜR BARIŞ TOPÇU

    Yüksek Lisans

    Türkçe

    Türkçe

    2019

    İnşaat MühendisliğiDokuz Eylül Üniversitesi

    İnşaat Mühendisliği Ana Bilim Dalı

    PROF. DR. BURAK FELEKOĞLU