Geri Dön

Polimer-polimer ve polimer-metal oksit kompozit sistemlerde film oluşum davranışlarının incelenmesi

Investigation of film formation behaviors of polymer-polymer and polymer-metal oxide composite systems

  1. Tez No: 323708
  2. Yazar: M. SELİN SUNAY
  3. Danışmanlar: PROF. DR. ÖNDER PEKCAN
  4. Tez Türü: Doktora
  5. Konular: Fizik ve Fizik Mühendisliği, Physics and Physics Engineering
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 2012
  8. Dil: Türkçe
  9. Üniversite: İstanbul Teknik Üniversitesi
  10. Enstitü: Fen Bilimleri Enstitüsü
  11. Ana Bilim Dalı: Fizik Ana Bilim Dalı
  12. Bilim Dalı: Belirtilmemiş.
  13. Sayfa Sayısı: 206

Özet

Bu çalışmada, polimer-polimer ve polimer-metal oksit kompozitlerden oluşan iki farklı sistemin film oluşum davranışlarını sırasıyla sert-yumuşak lateks ağırlık kesri ve sert parçacık (PS) boyutuna, PS film kalınlığı, PS molekül ağırlığı (MW), TiO2 ve Al2O3 inorganik içeriğine bağlı olarak inceledik. Bu sistemlerin film oluşum davranışları; kararlı durum floresans (SSF) ve UV-görünür (UVV) tekniklerinin atomik kuvvet mikroskop (AFM) ve taramalı elektron mikroskop (SEM) ile birlikte kullanılarak çalışıldı. Tüm çalışmalarda piren-(P), floresans molekül olarak kullanıldı ve polimerizasyon süresince polimer zincirlerine kovalent olarak etiketlendi. Elde ettiğimiz sonuçlardan, klasik lateks film oluşum işlemi, polimer molekül ağırlığı, film kalınlığı ve TiO2 içeriğinden bağımsız olarak, filmlerin üst kısmında gerçekleştiğini gördük. SEM görüntülerinden elde ettiğimiz sonuçlara göre TiO2, Al2O3 içeriği, PS lateks boyutu ve film kalınlığının, film oluşumu ve monodispers, mikronaltı inorganik oksit gözenek oluşumunda çok büyük bir etkiye sahip olduğu anlaşıldı. Bu sonuçlar, çalışmamızda kullandığımız en basit ve en ucuz teknik olarak daldırma ile kaplama tekniğinin farklı polimer/metal-oksit kompozit sistemlerine de uygulanabilineceğini göstermiştir.

Özet (Çeviri)

In this study, we investigated the film formation behaviors and morphologies of two systems of polymer-polymer and polymer-metal oxide composites depending on hard-soft latex weight fraction, the hard polystyrene(PS) particle size, film thickness, PS molecular weight (Mw). TiO2 and Al2O3 metal oxide content, respectively. Film formation behaviours of these composite systems were studied by using steady state(SSF) and UV-visible (UVV) techniques together with atomic force microscop (AFM) and scanning electron microscop (SEM). Pyrene was used as fluorescent probe in all studies and covalent labeled to the polymer chains during the polymerization reaction. The classical latex film formation process can take place on the top surface of the films regardless of the molecular weight, film thickness, PS particle size and metal oxide content. But the thickness of PS latex films, PS particle size, metal oxide content had greate influence on the film formation and structurel properties of the films. The measurement obtained from the SEM showed that the pore size and porosity could be easily tailored by varying the PS particle size and the Al2O3, TiO2 content. We anticipate that with this strategy, the synthesis of other highly ordered micro-macroporous metal oxide films should also be possible.

Benzer Tezler

  1. MEMS ile entegre mikro ısıtıcı ve IDE mikro sistemlerin fabrikasyonu ve nano kompozit yarı iletken gaz sensör uygulaması

    Fabrication of integrated micro heater and ide micro systems with MEMS and application of nano composite semiconductor GAS sensor

    HALİME İLBEYİİLİNGİ

    Yüksek Lisans

    Türkçe

    Türkçe

    2024

    Fizik ve Fizik Mühendisliğiİstanbul Teknik Üniversitesi

    Fizik Mühendisliği Ana Bilim Dalı

    DR. ÖĞR. ÜYESİ BERNA MOROVA

    DOÇ. DR. CİHAT TAŞALTIN

  2. Synthesis of 3,5-bis(perfluorobenzyloxy)benzyl acrylate containing polymers

    3,5-bis(perflorobenziloksi)benzil akrilat içeren polimerlerin sentezi

    TUBA ÇAKIR ÇANAK

    Doktora

    İngilizce

    İngilizce

    2012

    Polimer Bilim ve Teknolojisiİstanbul Teknik Üniversitesi

    Polimer Bilim ve Teknolojisi Ana Bilim Dalı

    PROF. DR. İ. ERSİN SERHATLI

  3. Püskürtmeli kurutma ve termal bozunma prosesleri ile ZnO esaslı partiküllerin ve kompozit yapıların sentezlenmesi ve karakterizasyonu

    Characterization and synthesis of ZnO based particles and composite structures via spray drying and thermal decomposition processes

    ŞEYMA DUMAN

    Doktora

    İngilizce

    İngilizce

    2016

    Seramik Mühendisliğiİstanbul Teknik Üniversitesi

    Malzeme Bilimi ve Mühendisliği Ana Bilim Dalı

    DOÇ. DR. BURAK ÖZKAL

  4. Grafen nanoplatelet, nano gadolinyum oksit ve mikro silika jel katkılı epoksi kompozitlerin elektromanyetik kalkanlama ve akustik özelliklerinin incelenmesi

    Investigation of electromagnetic shielding and acoustic properties of graphene nanoplatelet, nano gadolinium oxide and micro silica gel filled epoxy composites

    İSMAİL MELİK TAŞ

    Yüksek Lisans

    Türkçe

    Türkçe

    2023

    Fizik ve Fizik MühendisliğiHacettepe Üniversitesi

    Fizik Mühendisliği Ana Bilim Dalı

    PROF. DR. SEVGİ BAYARI

  5. DOPO-based phosphorus and nitrogen rich flame retardant additives

    DOPO bazlı fosfor ve azot zengini alev geciktirici katkı maddeleri

    İREM GÜNDEREN

    Yüksek Lisans

    İngilizce

    İngilizce

    2024

    Kimyaİstanbul Teknik Üniversitesi

    Kimya Ana Bilim Dalı

    PROF. DR. İBRAHİM VOLKAN KUMBARACI