Bazı polimerlerin ve organik/inorganik hibrit filmlerinin sensör özelliklerinin incelenmesi
Investigation of the sensor properties of some polymers and their organic/inorganic hybrid films
- Tez No: 343816
- Danışmanlar: DOÇ. DR. HÜSNÜ CANKURTARAN
- Tez Türü: Doktora
- Konular: Kimya, Chemistry
- Anahtar Kelimeler: Nem sensörü, iletken polimer, poli(difenilamino sülfonik asit), impedans, kuvars kristal mikroterazi, Humidity sensor, conductive polymer, poly (sulfonic diphenyl aniline), impedance, quartz crystal microbalance
- Yıl: 2013
- Dil: Türkçe
- Üniversite: Yıldız Teknik Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Kimya Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 153
Özet
Suda çözünebilir iletken polimer; poli(difenilamino sülfonik asit) (EPSDA) elektropolimerizasyon ile sentezlendi ve karakterize edildi. EPSDA ve nano oksidler (nano ZnO ve nano Al2O3) içeren organik/inorganik hibrit nanokompozitler nem sensörleri elde etmek üzere hazırlandı. (3-merkaptopropil) trimetoksisilan (MPTMS) algılayıcı tabakanın kararlılığını artırmak ve hidrofiliklik derecesini ayarlamak üzere kompozitlere eklendi. Hazırlanan ince film sensörlerinin nem algılama özellikleri LCR metre ve QCM ile incelendi. LCR metre ile yapılan ölçümlerde, EPSDA-MPTMS içerikli organik/inorganik hibrit filmler ve EPSDA-MPTMS-nanoZnO ya da nano Al2O3 içerikli nanokompozitler hazırlandı ve interdigited elektrodlara ince film olarak kaplandı. Bu ince film sensörlerinin impedans, reaktans ve direnç gibi elektriksel özellikleri çeşitli bağıl nemler altında, 100-1 kHz frekans aralığında ve 0,2 V voltaj altında ölçüldü. Bu ince filmlerin bağıl nem-impedans değişimleri, cevap ve geri dönüş zamanları, histeri ve tekrarlanabilirlik/geridönüşümlülük gibi nem algılama özellikleri ve çeşitli çözücü buharlarına karşı cevapları incelendi. Nano malzemelerin eklenmesi ile sensörlerin algılama özellikleri geliştirildi. % 50 nano ZnO-EPSDA-MPTMS (S7) ve % 50 nano Al2O3-EPSAD-MPTMS (S10), 1 kHz alternatif akım frekansı altında saf EPSDA-MPTMS sensöründen daha iyi nem algılama özellikleri gösterdi. S7 kodlu sensör hızlı cevap (cevap zamanı; 90 s ve geri dönüş zamanı; 60 s), iyi bir doğrusallık (R2=0,9832), % 10-95 nem aralığında tekrarlanabilir cevaplar ve düşük histeri sergilemektedir. Benzer şekilde, S10 kodlu sensör hızlı cevap/geri dönüş zamanı (65 s/55 s), iyi bir tekrarlanabilirlik, yüksek korelasyonla iyi bir doğrusallık (R2=0,9949) ve % 10-95 nem aralığında düşük histeri göstermektedir. Geliştirilen impedimetrik sensörlerin bazı çözücüleri algılama özellikleri çalışmasında, sensörün yapısına ve buharın konsantrasyonuna bağlı olarak, impedans değişimlerinin büyüklüğü ilgili çözücünün polaritesi ile ilişkili olduğu görüldü. Hazırlanan nem sensörlerinin polar organik çözücülere cevabı neme göre daha az iken apolar çözücülere karşı cevabı önemsizdir. Sensörlerin farklı bağıl nemlerdeki kompleks impedans grafikleri incelendiği zaman, genellikle, düşük ve yüksek RH?de farklı algılama mekanizmasını gösterir nitelikte artan RH ile eğrilerin şekillerinin yarım daireden düz bir şekle değiştiği görülmektedir. QCM ile yapılan ölçümlerde, ilk olarak, EPSDA ve MPTMS ince film kompozitleri nem sensörü oluştırmak üzere kuvars kristal elektroda kaplandı. Modifiye edilen QCM elektrodunun yüzeyindeki su buharının adsorpsiyonu ve desorpsiyonu sebebiyle meydana gelen direnç değişimi ve frekans kaymaları anlık olarak ölçüldü. QE1 olarak kodlanan sensor hızlı cevap/geri dönüş zamanı (70 s/44 s), iyi bir tekrarlanabilirlik, yüksek korelasyonla iyi bir doğrusallık (R2=0,9911) ve düşük histeri gibi iyi nem algılama özellikleri göstermektedir. İkinci olarak, ağırlıkça farklı yüzdelerde nano Al2O3 içeren EPSDA-MPTMS-nanoAl2O3 nanokompozitleri QCM elektrodlarına kaplandı. % 40 nano Al2O3 içeren EPSDA-MPTMS (QE4) hızlı cevap (cevap zamanı; 65 s, geri dönüş zamanı; 45 s), % 9,7?93 RH aralığında yüksek korelasyonla iyi bir doğrusallık (R2=0,9914) ve düşük histeri gibi mükemmel algılama özelliklerine sahiptir. Sensör cevaplarına bazı çözücülerin etkisi QCM ile incelendiğinde, geliştirilen sensörlerin organik çözücü buharlarına karşı cevaplarının önemli olmadığı saptandı. QCM yöntemiyle neme yüksek bir seçicilik elde etmek mümkün oldu. Ayrıca deneysel sonuçlar, geliştirilen sensörlerin yüksek kararlılık ve duyarlığa sahip olduğunu ve cevapların bir ay boyunca stabil kaldığını göstermiştir.
Özet (Çeviri)
A water soluble conductive polymer, poly(sulfonic diphenylaniline) (EPSDA) was synthesized by using electrochemical polymerization and characterized. The organic-inorganic hybrid nanocomposites containing EPSDA and nano-oxides (nano ZnO and Al2O3) were prepared to obtain humidity sensors. (3-mercaptopropyl) trimethoxysilane (MPTMS) was added into the composites to adjust the hydrophilicity and stability of the sensing layer. The humidity sensing properties of prepared thin film sensors were investigated by LCR meter and QCM. In the measurements by LCR meter, the organic/inorganic hybrid films composed of EPSDA-MPTMS and nanocomposites of EPSDA-MPTMS-nanoZnO or nanoAl2O3 were prepared and they were covered onto the interdigited electrodes. The electrical properties such as impedance, reactance and resistance of these thin film sensors were measured at various relative humidities in the frequency range of 100-1 kHz and under 0.2 V of potential bias. Humidity sensing properties such as relative humidity-impedance characteristics, response and recovery times, hysteresis, repeatability/reversibility and sensing capabilities against varied solvent vapors of the thin films were investigated. The sensing characteristics of the sensors were developed by the addition of nanomaterials. The nanocomposites with 50 wt% of ZnO-EPSDA-MPTMS (S7) and 50 wt% Al2O3-EPSDA-MPTMS (S10) showed better humidity sensing properties than pure EPSDA-MPTMS at 1 kHz alternating current frequency. The sensor coded as S7 exhibited quick response (response time, 90 s and recovery time, 60 s), good linearity (R2=0.9832), good repeatability in the humidity range of 10-95% RH and low hysteresis. Similarly, the sensor coded as S10 exhibited fast response/recovery time (65 s/ 55 s), good repeatability, good linearity with high correlation (R2=0.9949) and low hysteresis in the humidity range of 10-95% RH. In the study of some solvent vapors sensing properties of the developed impedimetric sensors, depending on the structure of the sensors and vapor concentration, the magnitude of the impedance changes correlated with the polarity of the exposed solvents. Compare with the humidity response, the prepared humidity sensors show lower response to other polar organic solvents, but insignificant response to non-polar solvents. When the complex impedance plots of the sensors in the different relative humidities were investigated, in general, it was seen that the shapes of the curves changed from a semicircle to a line with increasing RH, indicating different sensing mechanisms at low and high RH. In the QCM measurements, firstly, the thin films composed of EPSDA and MPTMS were coated onto the quartz crystal electrode to prepare humidity sensor. The frequency shifts and the change of resistance due to the adsorption and desorption of water vapor on the surface of the modified QCM electrodes were simultaneously measured. The sensor which was composed of EPSDA and MPTMS (QE1) shows good sensing properties such as fast response/recovery time (70 s/44 s), good repeatability, good linearity with high correlation (R2=0.9911) and low hysteresis. Secondly, the EPSDA-MPTMS-nano Al2O3 nanocomposites with different weight percents of nano Al2O3 were coated onto the QCM electrodes. The nanocomposite with 50 wt% Al2O3-EPSDA-MPTMS (QE4) showed excellent sensing properties, such as quick response (response time, 65 s and recovery time, 45 s), good linearity with high correlation (R2=0.9914) over the large humidity range (9.7?93% RH) and small hysteresis. When the effect of some solvent vapors on sensors responses were investigated by QCM method, it was determined that the responses of the developed sensors against organic solvent vapors were insignificant. It was be able to obtain high humidity selectivity by QCM method. Additionally, experimental results showed that the developed sensors have high stability and sensitivity and the responses were stable within one month.
Benzer Tezler
- Fabrication and characterization of P3HT-WO3 hybrid thin films and device applications
P3HT-WO3 hibrit ince filmlerin üretimi, karakterizasyonu ve cihaz uygulamaları
FATMA BEYZA YEDİKARDEŞ ER
Doktora
İngilizce
2024
Kimyaİstanbul Teknik ÜniversitesiNanobilim ve Nanomühendislik Ana Bilim Dalı
PROF. DR. ESRA ZAYİM
PROF. DR. MUSTAFA ALTUN
- Highly conjugated visible and near-infrared light photoinitiating systems for radical and cationic polymerization
Radikal ve katyonik polimerizasyon için yüksek konjugasyonlu görünür ve Nır bölgesi fotobaşlatıcı sistemleri
ALİ SÜERKAN
- Syntheses, characterizations, and device fabrications of organic molecules for energy storage devices
Enerji depolama cihazlarında kullanılmak üzere organik moleküllerin sentezi, karakterizasyonu ve cihaz uygulamaları
SEBAHAT TOPAL
- Controlled delivery of chalcone via biopolyester nanohybrid
Biyopoliester nanohibrit ile kalkonun kontrollü salımı
YASEMİN KAPTAN
Doktora
İngilizce
2022
Biyoteknolojiİstanbul Teknik ÜniversitesiKimya Mühendisliği Ana Bilim Dalı
PROF. DR. FATOŞ YÜKSEL GÜVENİLİR
- Nanomaterials in macromolecular synthesis
Makromoleküler yapıların sentezinde nanomalzemelerin kullanımı
AZRA KOCAARSLAN AHMETALİ
Doktora
İngilizce
2021
Polimer Bilim ve Teknolojisiİstanbul Teknik ÜniversitesiKimya Ana Bilim Dalı
PROF. DR. YUSUF YAĞCI