Pik demiri ve karbon çeliğinin sulu çözeltiler içindeki korozyon hızının tayini
Determination of the rate of corrosion of the cast iran and carbon steel in the aqueous solutions
- Tez No: 352
- Danışmanlar: DOÇ. DR. HAYRİ YALÇIN
- Tez Türü: Yüksek Lisans
- Konular: Kimya Mühendisliği, Chemical Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 1985
- Dil: Türkçe
- Üniversite: Gazi Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Kimya Mühendisliği Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 113
Özet
Bu çalışmada demir ve çeliğin sulu ortamda koroz- yon karakteristiğini saptamak amacıyla polarizasyon deneyleri yapılmıştır. Demir ve çeliğin katodik polari zasyonu $0,1, #0,5, #1,0, #2,0, #5,0 lik Na2S0 lı or tamlarda incelenmiştir. Deneylerde“beş elektrot Deş ayrı elektrolit içinde denenmiştir. Elektrotlar * font düktil, gri dökme demir, 1010 çeliği, inşaat de miri ve 1050 çeliğinden hazırlanmıştır. Elektrotlar kü~ bik biçimli ve 1 cm yüzeylidir. Çalışmalar oda sıcaklığın da sürdürülmüştür. Polarizasyon ölçümlerinde galvano statik metod kullanılmıştır. Elektrot potansiyeli akım yoğunluğuna göre okunmuştur. Akım yoğunluğu değerlerinden elde edilen yarılogaritmik eğriler kullanılmak suretiyle akım yo ğunluğu verileri korozyon potansiyeline kadar ekstra- pole edilmiş ve böylece korozyon hızı tespit edilmiş tir. Katodik polarizasyon çalışmalarında seçilen her bir akım için oluşan korozyon reaksiyonları, sulu-V- ortamdaki sülfat iyonlarının konsantrasyonuna ”bağlı olarak değişmiştir. Araştırmada, elektrolit konsantrasyonu ve cinsi nin korozyon hızına nasıl etkidiğinin belirlenmesine çalışılmıştır. Metallerin korozyon hızı inhibitor etkisine bağ lıdır. Bu nedenle aynı elektrotlar ile inhibitörlü ortamlarda da deneyler yapılmıştır. #5»0,llk Na2SO çözeltisine bazı inhibitörler ilave edilmiştir. Inhi bitor olarak HagHPÖ- Na2°4B7 ve KgCrO^ m kullanılma sı ile korozyon hızı yeniden ölçülmüş ve metal koroz- yonu üzerine inhibitörün etkisi incelenmiştir. Deneyler sonunda demir ve çelik içinde bulunan yabancı bileşenlerin korozyon hızına etkisi ve adi çe liğin sulu çözeltiler içindeki korozyonunda etkili olan faktörler ortaya konulmuştur.
Özet (Çeviri)
Polarization tests were carried out to determine the corrosion characteristics of steel and1 iron in aqueous environtments. The catodie polarization behavior of steel and iron in 0,1, 0.5, 1.0, 2.0, 5.0 percent NapSQ Five electrolyes and' five electrodes were used in the experiments. Electrodes were prepared from cast iron (ductile), gray cast iron, 1010 steel structural steel, 1050 steel» The electrodes were cubic in shape (area 1 cm ), An studies were carried out at room temperature. Polarization measurements were made with the galvanostatic method. Electrode potentials were measured with respect to current density. The current density data can be extrapolated bact to corrosion potential using a semilogarithmic plot to obtain the corrosion current density value. Thus corrosion rate is determined.-vii- In catodic polarization studies, the corrosion reactions that occur at any selecte-d current often dependent of sulfate ions content of the aqueous environment The effect of electrolyte concentration and types of steel and iron on the corrosion rate in aqueous, solution were determined. The rate of corrosion is related to inhibitor effect. Because of this several other experiments were carried out using inhibitors. Inhibitors were added to the 5 percent Na_SO Corrosion rates were determined by using inhibitors as NagHPO, Na?B O K2Cr°4# The results of this investigation have shown that the effect of iron and steel compositions on the corrosion rate were determined. These studies indicated that the effect of. factors in aqueous solutions on the corrosion rate of structural steel were determined.
Benzer Tezler
- Design of a stainless steel composite bridge according to the eurocodes and cost analysis
Paslanmaz çelik ile kompozit bir köprünün eurocode'a göre tasarımı ve maliyet analizi
TİJEN BAYER
Yüksek Lisans
İngilizce
2014
İnşaat Mühendisliğiİstanbul Teknik Üniversitesiİnşaat Mühendisliği Ana Bilim Dalı
YRD. DOÇ. DR. BARLAS ÖZDEN ÇAĞLAYAN
- Sıcak haddelenmiş çelikleri işleyen tesislerde biriken demir esaslı yağlı çamurdan demirli hammadde üretilmesi
Production of ferrous raw materials from iron based oily mill sludge released in the facilities processing hot rolled steels
SAMET BALLI
Yüksek Lisans
Türkçe
2019
Metalurji Mühendisliğiİstanbul Teknik ÜniversitesiMetalurji ve Malzeme Mühendisliği Ana Bilim Dalı
PROF. DR. MUSTAFA KELAMİ ŞEŞEN
- Demir çelik sektörü ve demir çelik sektöründe sermaye maliyeti
Iron and steel sector and cost of capital in iron and steel sector
ALİ DİKMEN
Yüksek Lisans
Türkçe
2002
İşletmeMarmara ÜniversitesiSermaye Piyasası ve Borsa Ana Bilim Dalı
YRD. DOÇ. DR. MAHMUT HAYATİ ERİŞ
- Farklı oranlarda alüminyum-bor oksit-karbon karışımlarından mekanokimyasal yöntem ile oda sıcaklığında Al2O3-B4C kompozit sentezi ve karakterizasyonu
Synthesis and characterization of Al2O3-B4C composites at room temperature by mechanochemical method from aluminum-boron oxide-carbon mixtures at different ratios
ÜMİT KOÇ
Yüksek Lisans
Türkçe
2018
Metalurji MühendisliğiDumlupınar ÜniversitesiMalzeme Bilimi ve Mühendisliği Ana Bilim Dalı
PROF. DR. REMZİ GÖREN
DR. ÖĞR. ÜYESİ HEDİYE AYDIN
- Manyetit cevheri konsantresinin karbonize çay tesis atıkları ile mikrodalga redüksiyonuna mekanik aktivasyon işleminin etkisinin araştırılması
Investigating the effects of the mechanical activation process on the microwave reduction of magnetite ore concentrates with tea plant wastes
ELİF ARANCI ÖZTÜRK
Doktora
Türkçe
2018
Metalurji MühendisliğiFırat ÜniversitesiMetalurji ve Malzeme Mühendisliği Ana Bilim Dalı
DR. ÖĞR. ÜYESİ MUSTAFA BOYRAZLI