Effects of re-emission on the evolution of surface morphology during thermal evaporation deposition
Başlık çevirisi mevcut değil.
- Tez No: 402518
- Danışmanlar: DR. TANSEL KARABACAK
- Tez Türü: Yüksek Lisans
- Konular: Fizik ve Fizik Mühendisliği, Physics and Physics Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2010
- Dil: İngilizce
- Üniversite: University of Arkansas at Little Rock
- Enstitü: Yurtdışı Enstitü
- Ana Bilim Dalı: Belirtilmemiş.
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: 112
Özet
Özet yok.
Özet (Çeviri)
In re-emission process during thin film growth, atoms that do not stick to the surface based on a sticking probability are re-emitted and can stick to other surface points. This process allows atoms to reach valleys of the surface, which are normally shadowed by higher surface points, leading to a smoothening effect. Although reemission has been applied to sputter deposition and chemical vapor deposition (CVD) growth modeling, which successfully predicts the dynamic morphological evolution, so far, no re-emission based modeling method has been developed for thermal evaporation growth. Thermal evaporation is a commonly used thin film deposition technique especially for low melting point elemental materials. Therefore, we developed a new growth modeling approach for thermal evaporation thin film deposition process that takes into the effects of re-emission. The modeling method is based on Monte Carlo simulation techniques and numerical solution of a continuum growth equation that include the effects of re-emission, shadowing, surface diffusion, and noise. Thin film morphologies obtained from Monte Carlo simulations and by numerically solving the growth equation were investigated for their dynamic evolution of surface roughness.
Benzer Tezler
- İstanbul'da kentleşmenin iklim değişikliğine uyum çerçevesinde değerlendirilmesi
Evaluation of urbanization under the climate change adaptation framework in Istanbul
ALİYE CEREN ONUR
Doktora
Türkçe
2014
Şehircilik ve Bölge Planlamaİstanbul Teknik ÜniversitesiŞehir ve Bölge Planlama Ana Bilim Dalı
PROF. DR. AZİME TEZER
- Investigation of the electrochemical co2 reduction mechanism on tin electrodes
Kalay elektrotlar üzerinde elektrokimyasal co2 redüksiyonu mekanizmasının incelenmesi
TUĞÇE YILMAZ
Yüksek Lisans
İngilizce
2020
Bilim ve Teknolojiİstanbul Teknik ÜniversitesiMalzeme Bilimi ve Mühendisliği Ana Bilim Dalı
PROF. DR. MUSTAFA KAMİL ÜRGEN
- Alkali ile aktive edilmiş harç ve atık çelik tel donatılı betonların (SIFCON) fiziksel, mekanik ve dayanıklılık özelliklerinin araştırılması
A study on the investigation of physical, mechanical and durability properties of alkali activated mortars and waste steel fiber reinforced concretes (SIFCON)
SAADET GÖKÇE GÖK
Doktora
Türkçe
2020
İnşaat Mühendisliğiİstanbul Teknik Üniversitesiİnşaat Mühendisliği Ana Bilim Dalı
DOÇ. ÖZKAN ŞENGÜL
- Türkiye kökenli aspir tohum yağlarının transesterifikasyonu ve dizel yakıt alternatifi olarak değerlendirilmesi
Transesterification of safflower seed oil of Turkish origin and its evaluation as a diesel fuel alternative
ASLI IŞIĞIGÜR